Enzymatic measurement of ammonia requires which substrates and coenzymes?

More Moaed E. Algazally's questions See All

What is the allowed time to transport of blood to patient after the working the cross match to the blood ?

What is the correct time to transport of blood to patient after the working the cross match to the blood?

07 August 2017 5,196 4 View

Over 70% of all medical decisions are based on laboratory results ?Why ?

Please i need any information to support this

07 August 2017 1,475 2 View

Which the biochemical parameters that can be used to helping in diagnosis the cause of dropping the hair ?

Which the biochemical parameters that can be measured in the laboratory to helping in diagnosis the cause of dropping the hair

07 August 2017 5,552 4 View

Ph value for venous blood is lower than in the arterial blood ? why

I think due to the buffering effects of hemoglobin (Hgb) known as the chloride isohydric shift....... yes or no

05 June 2017 4,080 4 View

How to determine the acid-base imbalance in the human blood.....

The pH should be checked first i think ....

05 June 2017 7,362 4 View

In the Henderson–Hasselbalch expression pH = 6.1 + log HCO3 –/dCO2, the 6.1 what is represents

this question for discussion

05 June 2017 2,936 2 View

Most laboratories consider less than 7.20 and greater than 7.60 the critical values for pH.

I don't know why the Most laboratories consider less than 7.20 and greater than 7.60 the critical values for pH.

05 June 2017 7,646 5 View

PCO2 calculated in blood ......

What is the PCO2 if the dissolved CO2 (dCO2) is 1.8 mmol/L?

05 June 2017 2,983 4 View

A renal-type aminoaciduria

Which of the following conditions is classified as a renal-type aminoaciduria? Fanconi syndrome, Wilson’s disease ,Hepatitis and Homocystinuria

05 June 2017 2,495 4 View

Creatinine synthesis increased in pregnancy, but plasma creatinine is usually low? Why

I think because the retention of fluid and the physiological rise in GFR that occur in pregnancy ,,,,,what do you say ,,,yes or no

05 June 2017 8,020 3 View

How does one derive the standard deviation of a scale?

Dear all, I am working on analyzing data from a survey on student satisfaction. The survey contains items with a 7-point Likert response format that produce 12 scales related to different areas...

05 August 2024 2,141 4 View

Why results of ROS flurescence are negative as there was no bacteria within?

Hello. I am working on ROS production of two systems: system A is cerium oxide and hydrogen peroxide, system B is cerium oxide nanoparticle, hydrogen peroxide and potassium bromide. I did some...

04 August 2024 5,974 3 View

Is it possible to improve the reforming section of the Haber-Bosch process without using air separation units?

A typical reforming section in a large-scale Haber-Bosch process (Figure 1) comprises two reactors. A mixture of methane (CH4) and steam (H2O) is fed into a primary reformer to produce syngas via...

01 August 2024 7,051 5 View

Why specific capacitance is not proportional with the specific surface area?

Dear researchers, Why specific capacitance is not proportional to the specific surface area? I have material A with a surface area higher than material B, but material B is showing little bit...

26 July 2024 9,156 2 View

Can I use CCCP instead of H₂O₂ as a positive control for ROS measurement through flow cytometry?

I am giving starvation stress to the soil amoeba (Dictyostelium discoideum) cells in my study groups and using NAC as a negative control. I am using DHE for ROS measurement.

20 July 2024 6,354 0 View

What is the correlation between IQ and job performance (measured by annual salary)?

I am struggling to attain multiple research articles, so far, I have looked at the Swedish longitudinal study, they have good depth and reliability. I was thinking of looking into twin studies to...

15 July 2024 3,737 1 View

Why flow rate of MFC for pure NH3 gas decreases with time?

We have been using MFC to control the flow rate of pure ammonia gas. The MFC is placed in an oven at 50 deg. C to avoid blockage due to NH3. However, after a few days of usage, the MFC is unable...

11 July 2024 5,796 1 View

Which part did I made a mistake?

I'm a postgraduate student and I'm currently researching ammonia nitrogen degradation through photocatalysis. The following experiment parameters are : 1. 200W Xe Lamp 2. 200mL aqueous ammonia...

10 June 2024 2,657 1 View

Correct spectrophotometry absorbance for colored turbid pond water samples?

I'm dealing with this pond water for analysis of chemical parameters such as (ammonia, nitrite, nitrate, phosphate...etc.) using a visible spectrophotometer while I was preparing standard curves...

03 June 2024 6,841 1 View

Please share the HNMR sample preparation procedure for isotopic labelling test to confirm source of N2 during ENRR to ammonia.?

During electrocatalytic nitrogen reduction to ammonia, we perform isotopic labelling test using HNMR to confirm source of ammonia.

29 May 2024 5,165 0 View