Does anyone know of a paper on the cyclic voltammetry of chalcopyrite and bornite?

More N.O. Lotter's questions See All

When communicating with multiple intelligences, why choosing with whom to communicate ends up with similar task performance?

When communicating with multiple intelligences, why choosing with whom to communicate ends up with similar task performance. I am experimenting in mpe's simpletag environment, where each...

22 May 2024 7,862 1 View

How to interpret a negative regression co-efficient in a PROCESS moderation analysis?

Hi, How do I interpret a significant interaction effect between my moderator (Coh) and independent variable (Hos)? The literature states Hos and my dependent variable (PDm) has a negative...

25 September 2023 3,331 4 View

Does this antenna showing circular polarization??? if yes, then how??

how to confirm circular polarization of attached antenna??? if yes, then how??

24 September 2023 9,576 4 View

Is there any height limit of RDRA for higher order modes?

Is there any height limit of RDRA for higher order modes? because in hfss simulation, with increase in height, gain didnt increase after a certain value. Need advise from DRA expert on this.

27 August 2023 2,927 0 View

How the <n> phase distribute in quasi-2D perovskite polycrystalline thin film?

In quasi-2D perovskite polycrystalline thin film, there are different phase. I want to konw that is there only one n-value phase or multiple n-value phases coexisting in a grain?

10 June 2023 6,001 2 View

Testing for associations between 2 continuous variables across 5 repeated measurements?

Hi All, I am searching for the correct statistical method to test if 2 continuous variables measured repeatedly (5 timepoints) in n = 20 subjects are associated with each other. The question to...

20 February 2023 8,995 3 View

How to determination the Gutmann’s donor number?

how to determination the Gutmann’s donor number? I want to konw the ethylene glycol.

11 November 2022 8,842 1 View

Is perovskite precursor solution colloidal dispersions?

I want to now why we call the perovskite precursor solution "solution", but there exist colloidal particles in it.

01 November 2022 1,416 6 View

How to extract peak coordinates from a given cluster with MATLAB as in the SPM results viewer?

Hello everyone, I am trying to extract peak coordinates from given clusters in an 3D fMRI group image, e.g. a thresholded ICA z-score map. Using MATLAB/SPM I am able to extract a single peak...

26 January 2021 8,163 2 View

Would you recommend some non-destructive equipment for assessment the shear wave velocity of soils?

I am studying on the structural health monitoring of historical buildings. To understand the seismic performance of structures, I would like to know the soil condition under the foundation of...

20 August 2019 4,238 8 View

How to calculate CCS for Sodiated adduct ions and Multiply Charged Ions?

I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...

08 August 2024 8,329 0 View

Inquiry on Maximum Nucleic Acid Volume for 2.5 mL Liposome Solution?

I am currently working on a project involving liposomes and need to determine the maximum volume of siRNA that can be added to a 2.5 mL liposome solution with a total lipid concentration of 10...

30 July 2024 6,420 1 View

How to determine the charge passing during a cyclic voltammetry?

Dear All, here is my question: if I have a 15-scans cyclic voltammetry performed with PalmSens, how can I obtain the charge passed during the process? Hopefully avoiding integrations,...

29 July 2024 3,733 5 View

How can I use DFT-D3 correction ( Siesta version 5.0.1)?

Dear Siesta Users, I installed Siesta 5.0.1 and I want to use Grimme's D3 correction. According to the 5.0.1 manual, I could use a few parameters to include the D3 correction in the...

27 July 2024 5,748 0 View

Why semicircle of nyquist plot is not complete?

While I am doing HER, I noticed that nyquist plots of Electrochemical Impedance Spectroscopy (EIS) is not complete. Will it affect for the Linear Sweep Voltametry (LSV) data? However, I can found...

26 July 2024 7,542 4 View

EDC carbodiimide and NHS easter 's half life among different pH?

It has been long known that EDC carbodiimide and NHS easter's half life agains hydrolysis are highly related to pH. However, very surprisingly, not yet found a paper giving a table/chart of their...

25 July 2024 8,738 0 View

Mechanochemistry: ball to powder mass or ball to powder volume?

I run mechanochemical reactions that involves the use of a large amount of catalyst (1:1 molar ratio to the reactant). When I try to understand the effect of amount of catalyst on the reaction, I...

23 July 2024 9,938 1 View

What binder would be the best choice to modify glassy carbon electrode with a 2D Material like Graphene or MXene?

I am trying to drop cast 2D Materials on Glassy Carbon Electrode for Cyclic voltametry and EIS purpose. What would be best binders to use?

23 July 2024 5,776 2 View

How to eliminate the carry-over effect in GC-MS/MS system?

Hi, I am a PhD student working at Jagiellonian University, Faculty of Chemistry. My work is related to the development of new analytical methods for the quantification of short-chain fatty acids...

22 July 2024 5,492 6 View

MDCI module in Orca software?

Dear Researchers, My question is associated with the "MDCI" method in Orca. Please let me clarify my question using a simple example: Suppose we are going to perform CBS extrapolation using "!...

21 July 2024 1,632 0 View

Khushbu Chauhan

You might find my work useful.

Preparation of CdTe thin film by electrodeposition in butyl methyl imidazolium bath at 80° C, KR Chauhan, IJ Burgess, GS Chang, I Mukhopadhyay

Journal of Electroanalytical Chemistry 713, 70-76

N.O. Lotter

Thank you very much Shabi, This is just what I was looking for. Norm

Denise Bevilaqua

You can see the pdf below. It might help you!