Does anyone know how can I simulate the DG unit using Power Factory?

More Mahboobeh Ghasemi's questions See All

What is the simplest way for modeling power distribution network?

I will be appreciated if you introduce me some book and article about it.

04 May 2016 2,133 4 View

Can anyone help me Finding the integral of sin⁡(x)dx using Upper and lower sums - Riemann Integrals by drawing figure?

I want to draw upper and lower rectangular for sin(x)dx over [-π,π] dividing the partition into 6 equal intervals. I only want the drawing and I can solve it. Best Regards,

04 May 2016 7,765 11 View

Can anyone suggest me some article to compare some optimization algorithms such as PSO, SA, FUZZY, GA and etc?

I want to analyse the optimization method of each approach. I am looking forward to hearing you,

03 April 2016 9,124 4 View

What is the best optimization algorithm such as PSO, SA, GA, FUZZY,... for determination of the optimal generation capacity for renewable energy ?

If you know some article about comparing this algorithms, I would be appreciate to tell me.

03 April 2016 302 9 View

Can anybody suggest me some thesis or articles regarding "optimal capacity for renewable resources"?

I was reading lots of article but I can't find any good thesis.Please help me to find them.

10 November 2015 995 5 View

Why CTs are connected in star on T/F delta connected winding side & in delta on T/F star connected winding side for T/F differential protection?

09 October 2014 2,143 2 View

How can I simulate nonlinear and differential equation with input using matlab simulink?

I want to simulate a nonlinear and differential equation with input like a linear equation using matlab simulink. I know how to solve with mfile but I want to learn using the simulink.

09 October 2014 3,220 5 View

What are the advantages of free wheeling diodes in full wave rectifiers?

Thanks.

09 October 2014 6,854 13 View

How many types of cooling system are there for transformers?

Thanks.

09 October 2014 2,657 7 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

How does grain and grain boundary affect the ceramic when studying its dielectric properties?

I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...

07 August 2024 5,177 3 View

Why is the molecule's orientation with an electric field affect polarizability?

Why is the molecule's orientation with an electric field affect polarizability? Electrons are diffuse enough to be independent with respect to orientation and effect of electric field on...

03 August 2024 7,843 1 View

When I simulate for S parameters using ADS, I have faced this issue that I have attached. Please anyone clarify me?

...

31 July 2024 1,671 3 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

Ternary in Electrical Engineering?

Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...

28 July 2024 5,771 2 View

In terms of chaos, what is the necessary and sufficient condition for authoritarianism, permanent or temporary, to come to exist and persist?

Since 2016 Brexit, the world needed to change the thinking behind traditional democracy as the democratic landscape changed, yet traditional democratic thinkers and actors have been acting as if...

28 July 2024 6,515 1 View

What topic or subject does Production Engineering need to address more?

Contemporary scores or innovations in scientific approaches. Hybrid methodologies, emerging themes and cross-cutting issues?

27 July 2024 648 3 View

Wrong out put for gmx x2top?

Dear users, I would like to simulate a zeolite structure in gromacs. I got the .cif file from IZA expanded in one direction in Materials Studio and exported a .pdb file. However, when I want to...

24 July 2024 367 4 View

Morteza Shabanzadeh Popular answer

Dear Ms. Ghasemi,

I recommend you study the following documents. Maybe they can give you some clue about it.

http://www.digsilent.de/index.php/products-powerfactory-application_examples.html#bottom

Regards,

Morteza Shabanzadeh

http://mortezash.blogfa.com/

Hossein Harimi

Dear Mrs. Ghasemi:

the paper can help for you

www.icrepq.com/icrepq'12/434-soriano.pdf

best regards,

Mohammad Amin

There are some tutorials and they are easy to follow. It could be helpful.