Due to its more rigid structure than other organic dyes,rhodamine B is stable or exhibits an extremely slow degradation under visible light irradiation .
Some dyes may be experienced to degradation upon exposure to sunlight especially in alkaline solutions. But, as prof. Yurii suggested, just try to do it.
Thank you very much. As my experiment, the UV-Vis absorption spectra of RhB dye increase after expose under visible light (555 nm). It means RhB is not degraded. Could you please explain this phenomenon?
Dye may has an isosbestic point ,equal absorption for all pH values at specific wavelength, at which the total absorbance of a dye does not change during a chemical reaction. Dye may show high assembly(dye aggregates) under light causing an increase in the absorptivity or cause the spectrum to become more intense.
Rhodamine B is ozo dye, stronger than methylene blue dye. It does not degrade itself without any catalyst or semiconductor in visible light or even in UV light.
Degradation of an organic dye pollutant under visible-light irradiation depends on the power of the light. With increasing the light power, the degradation of the pollutant increases.
Increase of the absorbance under visible-light irradiation can be related to dissolution of RhB during the photolysis condition. Please prepare the RhB solution about 24 h before the experiment. It the problem persist, please decrease concentration of the pollutant.
An increase in the absorbance may also be due to evaporation of the water in your solution, leaving behind a more concentrated solution. try controlling your reaction temperature and also if possible increase the volume of your RhB solution.
Generally, If aqueous solution of Rh B dye is placed under the visible light irradiation long time, the dye can degrade slightly and absorption spectra is slightly decreased. It also depends upon the distance between the light source and dye as well as light intensity, volume and concentration of dye solution. However, in short periods, the Rh B is difficult to degrade.
It can happen by both possibilities of dissolution as well as heating effect. You can use proper photoreactor with water circulation and check dye solution also to avoid this.
RhB is a stable dye and can not be degraded without the assistance of semiconductors under visible light illumination. The reason behind the increase in absorption intensity of RhB is the evaporation of water during illumination. You should maintain the temperature of the reaction while conducting experiments.
The aqueous solution of Rhodamine B dye and other dyes stuff also degraded under the UV-Vis light irradiation but there some parameters which are highly concerned like intensity of light, time that how long you put the Rh B solution, distance b/w dye solution and source of irradiation etc. It is degraded up to some extent, not up to significant value.
The aqueous solution of Rhodamine B dye and other dyes stuff also degraded under the UV-Vis light irradiation but there some parameters which are highly concerned like intensity of light, time that how long you put the Rh B solution, distance b/w dye solution and source of irradiation etc. It is degraded up to some extent, not up to significant value.