Difference between DSC and DTA graphs

Kasim Fawzy Ahmed @Kasim_Ahmed3

08 August 2016 1 7K Report

What is the difference between DTA and DSC characterization graphs (especially for glasses?

Kasim Fawzy Ahmed

thanks a lot my dear Michael Y. Wong for this priceless answer.

Which plot of them can be called thermograph?

Badges
Science topic

Similar topics
Mathematical Sciences
Graphs

More Kasim Fawzy Ahmed's questions See All

What is the different between the words spectroscopy and spectroscope?

What is the different between the words spectroscopy and spectroscope? for example, should we say Raman spectroscope OR Raman spectroscopy?

06 July 2017 2,972 10 View

In SEM, a dielectric specimen coated with a metallic.

Why in SEM, a dielectric specimen coated with a metallic? and why the metallic coating should be a carbon or gold?

06 July 2017 3,771 3 View

The meaning of the word "Recently" in scientific articles?

In scientific articles, we usually use new references so we say : Presently, a group of researcher found that.....[6, 10]. So, How much should our reference (as: 6 or 10) to be new when we said...

01 February 2017 1,055 0 View

Could Silver NPs be detected from IR spectroscopy?

Can we use the FTIR Spectroscopy to detect Ag NPs inside glasses?

11 December 2016 5,504 3 View

Why the glass is transparent?

Why the glass is transparent (Physically)?

06 July 2016 3,430 2 View

What is the difference between EDX and XRD?

Can both give us the same results?

06 July 2016 6,699 9 View

What make diamond so hard and glass so brittle?

Diamond has a higher index of refraction than ordinary glass, and is also more "dispersive". The index of refraction of diamond varies more with the wavelength of the light than does that of...

06 July 2016 2,034 2 View

Are there better metrics to measure scientific quality than impact factors?

Are there better metrics to measure scientific quality than impact factors? and does this a good way to measure scientific quality?

06 July 2016 601 0 View

Are impact factors a good proxy for scientific quality?

There is considerable discussion in the scientific world: Is the impact factors are a reliable instrument to measure scientific quality?

06 July 2016 3,995 0 View

What is the difference between single crystal XRD and powder ?

What is the difference between powder and single-crystal X-ray diffraction ?

06 July 2016 6,768 18 View

Fabrication of narrow glass capillary (inner diameter 200~500 nm)?

I need a very narrow glass capillary for my research. How can I make a glass capillary with an inner diameter of around 200 to 500 nanometers?

08 August 2024 8,915 0 View

Why does my protein refolded to beta sheet during thermal denaturation analysis?

Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...

06 August 2024 1,989 3 View

What is meant by baseline of FTIR data?

I got comment on my FTIR data figure from a reviewer. The reviewer said "FTIR data in Figure should be repeated. there is no bassline." I made Y off set comparison graph of FTIR on OriginLab. Can...

03 August 2024 6,070 3 View

Is the mentioned CV graph a valid one as this graph have only one peak prominent (reduction)?

I have used Prussian blue nanoparticles as a redox couple. The PBNPs have been made using only one salt precursor. Also, during scan rate studies, a small oxidation peak can be consistently found...

31 July 2024 9,697 0 View

Entropy measure and QSPR modeling in Graph Theor. How to construct the table for lengthy equation?

The entropy measured of molecular graphs plays a crucial rule. The network structures in some cases are very lengthy calculations to handle. Some author avoid to construct table where as most...

30 July 2024 3,126 0 View

There is possible way to calculate experimental DOS from the UPS spectrum of the material. How to calculate the DOS from UPS?

Here, I have attached the UPS graph. I'm trying to calculate the DOS/DOVS from the UPS.

29 July 2024 4,971 1 View

Critique Calculaltion in Topological Indices and QSPR Modeling?

The first step is to analyze a 2D molecular graph and implement partitioning techniques to calculate the topological indices. Secondly impose statically tools to generate QSPR model, may or may...

24 July 2024 9,644 1 View

How to do calculation of Louvain methods calculation for excel sheet and and is there any software available?

The Louvain method – named after the University of Louvain where Blondel et al. developed the algorithm – finds communities by optimizing modularity locally for every node’s neighborhood, then...

23 July 2024 6,659 0 View

Is it possible to manufacture polypropylene sheets using a biaxial process?

I know that films and other low-thickness laminated products are produced using biaxial orientation, but is there something similar for sheets with a thickness of around 6 mm? Or are they...

21 July 2024 1,559 1 View

Appearance of crystallization peak in heating cycle of DSC test?

For which types of polymers, the crystallization peak in heating cycle of DSC test can be observed and for which types cant? In another word, when this exothermic crystallization can be observed...

18 July 2024 348 3 View