Can u give me the cicuit diagram Capacitive transimpedance amplifier ROIC technique?

Prashant Saxena @Prashant_Saxena9

06 June 2016 1 6K Report

I actually want to simulate this circuit in pspice orcad capture. So the proper cicruit diagram is required.

U. Dreher

The following link should be able to help:

http://fp.optics.arizona.edu/detlab/Classes/Opti566/OPTI566_Spring12/Lecture-Notes/Lesson-11.pdf

BTW: found this document by googling 'Capacitive transimpedance amplifier ROIC' :)

Re modelling: get the model of a TIA, add the feedback cap, a switch (eg. MOSFET) to reset and appropriate voltage sources. Where exactly is the problem ?

Whish you success

Badges
Science topic

When I simulate for S parameters using ADS, I have faced this issue that I have attached. Please anyone clarify me?

...

31 July 2024 1,671 3 View

What are some signs that an ECM is overfitting the Nyquist plot?

What can you look for to know that the circuit model being used is overfitting the data. How do you know when overfitting is occurring?

31 July 2024 7,425 0 View

Why specific capacitance is not proportional with the specific surface area?

Dear researchers, Why specific capacitance is not proportional to the specific surface area? I have material A with a surface area higher than material B, but material B is showing little bit...

26 July 2024 9,156 2 View

Wrong out put for gmx x2top?

Dear users, I would like to simulate a zeolite structure in gromacs. I got the .cif file from IZA expanded in one direction in Materials Studio and exported a .pdb file. However, when I want to...

24 July 2024 367 4 View

Can a shoot-through event of a tri-state digital buffer cause momentary Hi-Z state?

// interested in the difference between floating events and short circuits.

22 July 2024 6,565 0 View

Can a private laptop with 16GB RAM and Intel i5-1235U 1.3 GHz processor be used for WRF simulation with a 12*12 km domain?

I want to simulate WRF for a 12*12 km domain size. I want to run LSM and BSM models with a 5 minutes time interval. My laptop specification is 16GB RAM and Intel i5-1235U 1.3 GHz processor. Can I...

13 July 2024 2,037 0 View

What is the best software for simulation of mode locked diode laser?

Hi Dear All I would like to simulate a mode locked semiconductor laser. Does anyone know what is the best software to do it?

06 July 2024 1,648 4 View

How to find experimental demonstrations are available on MEC research using OMNET?

I attempted to find a tutorial on YouTube but couldn't locate it. Could anyone guide me on how to view simulation results for Mobile Edge Computing using the OMNET++ simulator?

06 July 2024 6,229 0 View

Does the specific capacitance value decrease or increase over time?

Will these measurement results change, for example, 1 month after the first measurement (e.g. CV, EIS) of the electrode or supercapacitor device? If it changes, how will it change? Is there an...

03 July 2024 3,644 2 View

Can SimaPro be used to simulate/analyse Biodegradation of Specimens?

I am looking at ways to investigate the biodegradation of 3D printed specimen as part of my research. To what extent can SimaPro be used to do this? The idea is to demonstrate the biodegradation...

02 July 2024 2,730 2 View