How to remove the residual PDMS on the silicon mold?

Incompletely cross-linked pdms are difficult to remove.

01 March 2021 798 3 View

How to prepare a thin polymer film by post-polymerization/crosslinking?

24 February 2021 2,362 5 View

How to remove the species data from rda data frame in R (only remain the sites/samples point)?

Dear everyone, When I using the rda function in r, I met this question. As you can see in the figure, there are a lot of deep blue points which refers to the species. But I would like remain...

15 February 2021 8,982 2 View

Mixed ANOVA or Multilevel modeling?

Hi everyone, I'm having some questions about choosing the right test for my experiment and I hope I can find help here! Here are the settings of the experiment: 1. participants are randomly...

14 February 2021 1,028 4 View

Does anyone knows about a comercial software to record pressure and temperature during reaction in an Autoclave?

Dear all: Currently I am working with polymerization reaction in a reactor. For this, I need to control temperature, pressure, agitation speed etc. For calculation of rate of polymerization, I...

07 February 2021 355 2 View

How to obtain the plot of frequency shift w.r.t. pressure in a micro resonator (cc beam) based MEMS pressure sensor in COMSOL?

I need to know how to plot the impact of pressure (0 - 100 kPa) (which is applied on the back side of diaphragm) on the frequency shift caused in the cc beam supported on the diaphragm with...

01 February 2021 5,805 17 View

How to simulate enzymatic hydrolyis of sucrose in a CSTR coupled with ultrafiltration membrane with comsol?

Dear all, I am trying to simulate the enzymatic hydrolysis of sucrose with invertase in CSTR in Comsol. The reaction pathway is such that Sucrose + Water -> Fructose + Glucose. It is desired...

27 January 2021 2,525 4 View

How to design an Ultrafiltration membrane for a CSTR?

Dear all, I am designing an Ultrafiltration (UF) membrane coupled with a CSTR. It is desired to utilized a dead end stirred reactor. The main purpose is to separate the enzyme used from the final...

27 January 2021 7,924 1 View

How to do variation partition for a distance matrix for microbial ecology?

I have bacterial, fungal, and protist OTU table. I want to know to what extent protist and fungi distribution can explain the bacteria distribution. I only know Mantel test could do a correlation...

11 January 2021 4,164 2 View

What is the simplest way to implement data encryption for Arduino project that communicate through Bluetooth ?

I have developed a project based on Arduino that communicates through Bluetooth with Android application, I want to enhance its privacy through encryption so that data should be prevented up to...

07 January 2021 7,933 5 View

Resistor definition in Piezoelectric bimorph with ANSYS workbench

Hello, good day! I am trying to simulate similar bimorph piezoelectric harvester with below commands. However, the output power doesn't change with resistor value. Please help to find the reason. ET,10,CIRCU94,0 !SET UP RESISTOR R,1,100000 !RESISTANCE VALUE TYPE,10 !SET ELEMENT TYPE E,1,2 !CREATE RESISTOR BETWEEN NODES 1 AND 2 Thanks in advance Regards,

02 March 2021 0 0 View

What are the most reliable approaches to extract key continuous frames from a video, with complete automation?

I have an input video, of skin (from a microscope that means it is magnified such that blood capillaries are visible). The idea is to extract 15 sec of continuous frames from a video of 1 min,...

02 March 2021 2,735 2 View

New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before?

Question to you and THEM, the New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before? There appears to be a core problem for...

02 March 2021 3,024 2 View

Which is the best place in the world for the plant biotechnology research?

I am searching for a good place for the Post Doc,

02 March 2021 4,053 3 View

Does anyone know HRM channel in a 2 plex QIAGEN Rotor- Gene Q qPCR can be used as a separate channel?

I am going to have 3 different probes in my qPCR work that I am going to do. But I realized that the machine we have in the lab is a Rotor-Gene Q 2plex HRM Platform, saying it has green, yellow,...

01 March 2021 8,544 1 View

How can extract ciprofloxacin hydrochloride disolve in water er to organic solvent such as dichloromethan or any other solvent?

I need a procedure to extract the ciprofloxacin hydrochloride from aqueous solution by using dichloromethane in detail,. I thank you very much.

01 March 2021 4,306 1 View

Which bacteria are suitable for quorum sensing screening?

I want to find a quorum sensing inhibitor from plant extracts. Klebsiella pneumoniae, Moraxella catarrhalis, Staphylococcus aureus, and Streptococcus pneumoniae. I looked for these strains...

01 March 2021 7,675 3 View

Isolates of Hymenoscyphus fraxineus?

Dear Dr. Cai, my name is Simone Prospero and I work in the team of Phytopathology at the Swiss Federal Institute for Forest Snow and Landscape Research (WSL;...

01 March 2021 1,133 1 View

How to perform statistical analysis of coefficients extracted from transform techniques?

I am studying the potential of DCT and FFT coefficients extracted from a signal to classify the different objects that emit the signal. I applied the Shapiro-Wilk to confirm that data was not...

01 March 2021 8,079 2 View

How to define tie constraint between rigid body and another part in dynamic explicit model of Abaqus?

Hi dear researchers I connected a rigid body into the part of my structure by tie constraint and then I added displacement to rigid body, in static general step every thing is fine and these two...

28 February 2021 3,442 2 View