I have seem active power ramp rates defined across 60 second intervals (or a minute), with the corresponding units reading as MW/min or kW/min.
I am working with original active power data that are recorded on average every 7 seconds, and am wondering if I can derive and calculate ramp rates over 7 seconds with units reading kW/7Sec ?
I suggest you pick relevant keywords for your question so that ResearchGate shows it to right audience. Now the only keyword is: "Architectural Accessibility"
Yes, as rise and fall of power demand is not with same rate, it would be better to have smaller interval for better accuracy and precision. Could use ADC with specific time interval sampling to find MW/Tunit..
Dear Mohammad Royapoor
The answer is yes. I suppose the smaller intervals would be better especially in RES systems...But you should always consider the burden of calculations if it is important in your work. It matters to run a time-accuracy trade-off in this regard.
Good luck
- Badges
- Science topic
- Similar topics
- Comment