Ok, I carried out theoretical calculation of MO constants and then sensitivity values of multilayers that I optimized through modeling and simulation. Note that no single sensitivity definition was available in literature when comparing the performance of SPR and MOSPR sensors side by side. Motivated by this problem, for the first time in biosensing history, I (in collaboration) systematically benchmarked and highlighted differences between the SPR responses in noble metal, and transition metal, and noble/transition metal bilayers. This serves the general readership who is not familiar in the topic to contextualize the results. I then benchmarked the common sensitivity metric that permits direct comparison of SPR and MOSPR responses at the optimal operating point. Have not seen this result yet? Feel free to download through the following webpage (free of cost):

http://www.mdpi.com/2304-6732/5/3/15

This sensitivity metrics should form the foundation for comparing two different types of sensors based on propagating surface plasmons which was so far not possible to do, to the best of this authors knowledge.

3) Drew schematics to build a lab for magneto-optics (started from nothing)

4) Ordered components through vendors

5) When components arrived, I built the lab, carried out optical alignment, and did what an optical engineer would do in a lab to build a functional laboratory (It was fun to take the challenge, although it was not easy to start in the beginning but the job is successfully done)

6) Successfully tested the functionality of the sensor in air and water media. It was great fun to demonstrate the physics of magneto-optics using the home-built lab.

7) Now, I would like to move on to testing bio-samples (enough test is already done with air and water media). Can anyone suggest where should I start for bio-sensing test with real samples? The sensor is based on propagating surface plasmon resonance. Thanks.

More Conrad Rizal's questions See All
Similar questions and discussions