Dear Research Gate Users,
I am searching for method of soil sample preparation for PAHs determination with GCMS. My GCMS equipment is Agilent 7890/5977A, GC column HP-5MS UI. Some of advisors suggest me use a method of Agilent: Analysis of PAHs in Soil with Agilent BondElut HPLC-FLD (attachment). At the end of the method he proposed me to evaporate ACN solvent using sample concentrator and dilute sample using solvent dedicated to GC-MS.
Thank you in advance,
Andrej
Dear Andrzej
Selection of the sample preparation technique depends on your purpose of the analysis and also on the available equipment. Personally, I recommend PLE (EPA 3545), which usually provides excellent results. But, provided you can validate the method, every other technique may work as well; Soxhlet, microwave or ultrasonic assisted solvent extraction, MSPD and so on.
Dear Amir,
Thank you for your answer. EPA 3545 look good but we have not any equipment for pressurized liquid extraction. But we have microwave oven - MARS5. I 'll try to check procedures. Thanks a lot.
Dear Andrzej,
both ASE (pressurized liquid extraction) and classical Soxhlet give the highest recoveries of target analytes, using hexane/acetone as an extraction solvent ( some of my colleagues prefer dichloromethane). With ultrasonic extraction ( and above mentioned solvents), the recoveries are significantly lower.
With your single quad, you will get better LOD/LOQ than with HPLC/FLD and the selectivity will be better, too. On the other hand, with 5-ms column, separation of relevant isomers on mass 252 (benzo b-, benzo k-, and benzo j- fluoranthenes ) is insufficient.
Hope it helps,
kind regards, Tomas
Dear Andrzej,
I am using Ethyl acetate with ultrasonic extraction for the first step and mix of Acetone- Pentane(50-50) for second step of extraction.
--
Best
Fatemeh
Dear Fatemeh, can you suggest some method? Probably I will use method used by you. Where I can find it?
Thank you
Best regards
Andrzej
- Badges
- Science topic