This would help me include the papers or journals as references and also study their work to find out their limitations and carry out further studies on their work.
Thank you.
The following information may be useful for your research
A welding procedure (WPS) for MIL A46100 steel armor joints using the gas metal arc welding process (GMAW)was developed and qualified according to mechanical and non-destructive (NDT) requirements of military codes. Obtained results
were compared to shielded metal arc welding (SMAW) procedures used to weld this type of steel. It was found that designed WPS is a suitable option to weld MIL A46100 armors according to the results obtained. In addition, a narrower heat affected
zone (HAZ) was obtained with designed WPS which should lead to a better in-service armor performance according to results of previous studies. Finally, an increase in Charpy v-notch (CVN) test impact energy compared to the SMAW procedure was found
DEVELOPMENT OF A WELDING PROCEDURE FOR MIL A 46100
ARMOR STEEL JOINTS USING GAS METAL ARC WELDING
DAVID MAZUERA ROBLEDO, JOHN ALBERTO SUÁREZ GÓMEZ J ORGE ENRIQUE GIRALDO BARRADA
Dyna, año 78, Nro. 168, pp. 65-71. Medellín, Agosto, 2011. ISSN 0012-7353
www.scielo.org.co/pdf/dyna/v78n168/a08v78n168.pdf
- Badges
- Science topic
- Similar topics
- Engineering
- Electrical Engineering
- Electrodes