I want to design zinc-air battery.
I want to test my material for ORR and OER activity.
11 January 2022 9,511 4 View
i am working on boron triangular super-cell.
12 February 2016 1,671 1 View
I am looking for the protocols in order to do standardizing expression of the inflammatory genes at gene level, when induced with some neurotoxins and I am unable to decide which reagents i...
22 November 2011 4,538 2 View
I want to learn more of the layering and purpose of layer in two different regions of brain
04 October 2011 466 3 View
Air moisture harvesting Air water collection devices
06 August 2024 5,473 2 View
I imagine the battery drives the graphite into a carbocation, then chloride is oxidized to donate the electron to the carbocation, but what pushes the lost electrons of chloride to be shared...
03 August 2024 5,384 0 View
Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity? What is the acceptable percentage of error (regardless of the metric)? Could you suggest...
03 August 2024 5,358 0 View
I am an Mphil research student and looking for high impact factor battery related journals to download and read research articles to improve my knowledge and get new ideas in the field of battery...
01 August 2024 6,516 2 View
I have attached the charging curve from the battery tester for review. I need help on what is happening
21 July 2024 6,898 2 View
please suggest the research paper related to the instrument is used in it.
16 July 2024 8,453 1 View
I need to plot cycle number vs. capacity with multicurrent density. please let me know if my steps are right or not as the below picture
14 July 2024 7,702 2 View
Would an average spot welder suffice for welding tabs for pouch cell electrodes instead of an ultrasonic one? Why would an ultrasonic welder be better than a regular spot welder?
10 July 2024 8,763 0 View
I tried to make slurry for NCM cathode but there was problem in coating process. The detail of my experiment is following; The ratio between active material(NCM811), conductive additives(Super-P)...
08 July 2024 7,327 4 View
The difficulty lies in how to miniaturize the battery. The sample holder is only 6.5mm, which means that the width or height of the battery cannot exceed 6.5mm (the height is about 3cm). I hope...
05 July 2024 8,141 0 View