Can anybody tell me the plastic behavior of Ti6Al4V alloy at room temperature?

08 August 2016 1 2K Report

Can anybody tell me the plastic behavior of Ti6Al4V alloy at room temperature? The strain rate is not high, I just need it to do some indentation simulations, as shown in the attachment.

Erik Carton

At room temperature Ti6Al4V is a strong (hard) but ductile material.

Until its failure strain it behaves ductile. This material is prone to adiabatic shear banding (localization of strain in a plane), but only at high strain rates and shear loading.

Badges
Science topic

More Longhui Meng's questions See All

Can anybody tell me the the creep behavior of Ti6Al4V alloy?

Can anybody tell me the the creep behavior of Ti6Al4V alloy? What exactly I want to know is the relationship between the strain rates and the stresses under different temperatures, including the...

06 July 2016 1,430 2 View

How can I measure the surface residual stresses generated by machining using non-destructive method?

The thickness of the stess layer generated by machining is very thin, the changing rate of the stress value along the depth direction is very high, conventionally, the stress values are measured...

07 August 2015 2,062 7 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

Arena simulation - how do i model the following model in ARENA (see description) (new to ARENA)?

Hello, I'm fairly new to ARENA and I have the following problem: I have two queues in which, in each queue, a different order type arrives (both having an arrival rate of exponential 10). Order...

02 March 2021 2,431 3 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

Which is the most efficient etching solution for nickel based alloys?

Which solution reveals the microstructure and features of nickel-based alloys?

02 March 2021 2,221 3 View

New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before?

Question to you and THEM, the New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before? There appears to be a core problem for...

02 March 2021 3,024 2 View

Why the results when using wall thickness and when using shell conduction are different in ansys fluent?

Actually, I am running cfd simulation for a heat exchanger which has two fluids one hot and other one is cold fluid. there is a solid domain between them, which I removed and instead I have used...

01 March 2021 9,537 2 View

Joint behaviour in Abaqus is not captured well?

I am working on roof joint and trying to simulate the behaviour in Abaqus. I am successful in running the model but the final graph does not follow the experimental curve in the negative direction...

01 March 2021 6,661 3 View