18 October 2016 5 6K Report

I have a few queries about broadbanding a microstrip patch antenna:

1) Understanding intuitively the working of a microstrip with parasitic element. Varying the parameters like gap between the patch and parasitic element, dimensions of parasitic element can be done and results observed in CST but would like to know if one can understand without simulating say the effect of one of these parameters on the output. Or is this too complex to be manually interpreted?

2) Say for getting a broadband patch at 83 GHz what procedure should be followed. First design a patch at that frequency and then add a parasitic element and vary dimensions etc? Any opinion on the same would be very welcome.

3) Any relevant book/publication on the same.

More Arka Halder's questions See All
Similar questions and discussions