Best Solvents for Preparing Solutions to Measure EC and UV for Transition Metal Acetylacetonate Complexes (Fe, Mn, and Cu)?

More Lamyaa zyad Alsebehen's questions See All

What is the difference between objective methodology and subjective methodology?

what is the difference between objective methodology and subjective methodology?

05 March 2024 7,813 2 View

Is the CBD deposition method better than the thermal chemical spray method?

Comparison of CBD by water bath is better or the method of deposition by thermal chemical spray

25 August 2021 5,515 2 View

Are there any benchmarking airborne LIDAR data and aerial image or multispectral LIDAR data and aerial image ?

i need a benchmarking data in airborne LIDAR data and aerial image or multispectral LIDAR data and aerial image ?

16 March 2021 9,956 3 View

Can we combine tow dimensional reduction methods?

Hi there can any one explain to me if we can combine two dimensional reduction methods to reduce more features? is there specific conditions to do that? (for example NPE and PCA)

08 May 2018 1,093 7 View

Which type of compound does lamda max of 218 indicate in a uv-vis spectrum of a partially purified compound through column and TLC?

A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...

11 August 2024 9,801 2 View

Baseline drift in HPLC? What causes this?

Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!

11 August 2024 3,770 4 View

Why Do TDS and EC Increase with Larger Wastewater Volumes, While BOD and COD Decrease?

I have carried out MFC experiments on three different volumes, 50, 500 and 1000 mL of wastewater. Results after MFC treatment shows that TDS and EC are more in larger volumes of water i.e. TDS and...

09 August 2024 9,621 0 View

How to calculate CCS for Sodiated adduct ions and Multiply Charged Ions?

I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...

08 August 2024 8,329 0 View

U you think We need a website software of Blackbody radiation law expert software?

A website software of Blackbody radiation law expert software can used through the following web site. http://39.105.188.151:3000/index

07 August 2024 1,706 0 View

What is the solvent for 8YSZ nano material?

I need to do some experiment with it in liquid form.

07 August 2024 613 3 View

How does grain and grain boundary affect the ceramic when studying its dielectric properties?

I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...

07 August 2024 5,177 3 View

Why is the molecule's orientation with an electric field affect polarizability?

Why is the molecule's orientation with an electric field affect polarizability? Electrons are diffuse enough to be independent with respect to orientation and effect of electric field on...

03 August 2024 7,843 1 View

Which solvent is better to dissolve with secondary metabolites extracted from fungi?

I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...

03 August 2024 4,725 2 View

Where can I find free research instruments for Nursing?

for eg. transition shock scale

01 August 2024 5,998 0 View

Tesfaye Lamma

You should have to use solvent ratio

Kyle A. Grice

Hi,

I would recommend using the same solvent for both measurements. FYI I would expect most M(acac)n to have no conductivity, but if you mean electrochemistry (CV) then acetonitrile, DMF, or DMSO would work for both e-chem and UV-Vis.

-Kyle