You means that you want to run the code n time and save the results for every run?

Thank you, i figured it out.

Hello, Reem and Huy Tran-Manh,  I am also doing similar kind of problem. But I am facing one problem during FoS calculation of slope, FoS terminates immaturely after running 1 single run. How should I solve it? Your help is appreciated.

Hey,

I think your problem is that you cannot run several FOS calculations after each other directly? 

Yes. After performing 1 single run, it is stopping. But at that time it is taking proper values of c, phi, etc. 

yes it is the natural process. I solved it by creating a dat file you call in flac in which inside it you call the files that calculate the fos, repeated n times according to how many run you need to do.

I am not getting your point. Attached is one which I have written. Can you just see it and tell me where I am getting wrong? 

what are you trying to change in every fos calculation?

In each FoS calculation, cohesion(c) and angle of friction (f) is chnaging. Basically, it will take one c, one phi in a single run and will calculate one FoS then it will take next c, phi value and give corresponding FoS.

yes i noticed this. I divided everything in files and they get called in one main file. For example, if you are changing the properties for 10 diff values, this main file repeats calling all the files 10 times i mean you write "call ... call ..." 10 times.

Hope this helps ;)

Ok I shall check and let you know. Thanks very much.