Hello, I'm trying to simulate the separation of solids (crystals formed by a crystallizer) and a liquid on ASPEN PLUS using centrifuge filters (CFuge), but I'm getting this error:
** ERROR
FAILED TO GET TVD. BLOCK BYPASSED.
I don't understand, does anyone know how to solve this error or know what it means?
Muhammad Zohaib Safdar
Check the input specifications: Make sure that you have entered the correct input specifications, including the feed flowrate, solids concentration, and operating pressure. Double-check that the units are consistent and match the unit set in Aspen Plus. Verify the physical properties: Confirm that you have entered the correct physical properties of the components used in the simulation. Physical properties such as density and viscosity are critical parameters in centrifugal filters. Check the model parameters: Make sure that the model parameters for the centrifugal filter are correctly set up in Aspen Plus. Check that the appropriate correlations are selected for the separation efficiency, pressure drop, and other relevant parameters. Check for convergence issues: If the simulation is not converging, it could be due to poor initial estimates or convergence parameters. Try adjusting the convergence criteria or use different initial estimates. Check for errors and warnings: Look for any errors or warnings that are displayed in the simulation window. These messages can provide important clues to identify the cause of the problem. Consult Aspen Plus documentation: If none of the above suggestions resolve the issue, refer to the Aspen Plus documentation or seek assistance from the Aspen Plus support team. They can help you identify and resolve the issue.
There could be several reasons why the simulation of a centrifugal filter (CFuge) in Aspen Plus is not working. Here are a few troubleshooting tips to help you identify the issue:
0 votes
0 thanks
- Badges
- Science topic
- Similar topics
- Heat
Similar questions and discussions