Calcium Hydro Silicates (CSH) are products of SiO2, Ca(OH)2 and water. Are there any values available that classify these CSH based on their compressive strength, but considering their synthesis is performed under low hydrothermal reaction?
[I]Compressive strength
fc ε{ 16.5; 61.5 MPa}
[II]Density of dried bricks D ε {166.1;1874 kg/ m3}
REFERENCE:
The Scientific World Journal
Volume 2014 (2014), Article ID 829794, 5 pages
http://dx.doi.org/10.1155/2014/829794.
Thank you very much!
Perlite characterisation - any suggestions to as where to publish my research?
10 November 2017 2,814 2 View
What is the percentage of porosity required for a ceramic material to be classified as porous? Is there such classification? I've seen in literature some consider 30% to be porous, some 65%. Can...
05 June 2016 6,567 6 View
Does anyone have the ISO standard for porosity of ceramic materials?
01 February 2016 6,221 2 View
Greetings, Can anyone guide me as far as the most current standard in regards to the compressive strength of porous ceramics products?
31 December 2015 7,422 4 View
How can I determine a good adhesion strength range for coatings on polymer surfaces, such as DLC on polymer substrates? Is there a specific threshold for adhesion strength (from T-peel tests)...
10 August 2024 942 3 View
I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...
09 August 2024 5,048 2 View
Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...
06 August 2024 1,989 3 View
I am working on Abaqus/Explicit(Quasistatic ) for the deformation of the auxetic structure model. Please explain how the plastic input value should be considered from the true stress-strain curve...
05 August 2024 454 3 View
How do you tie-break and rank these two in their strength?
03 August 2024 4,471 1 View
Machine learning (ML) has shown great potential in predicting the compressive strength of concrete, an important property for structural engineering. However, its practical application comes with...
03 August 2024 2,546 2 View
I'm working on the atmospheric water harvesting, and i synthesized MOF by adding some materials into precursor and changing the conditions. (i followed Hydrothermal method) Actually, if MOF is...
24 July 2024 1,515 0 View
The Louvain method – named after the University of Louvain where Blondel et al. developed the algorithm – finds communities by optimizing modularity locally for every node’s neighborhood, then...
23 July 2024 6,659 0 View
Thanks
22 July 2024 1,143 3 View
I know that films and other low-thickness laminated products are produced using biaxial orientation, but is there something similar for sheets with a thickness of around 6 mm? Or are they...
21 July 2024 1,559 1 View