I would be happy if someone could give me some references to work (esp. Masterthesis) dealing with the problem of chemical milling of titanium. In particular for etching for wire fabrication. Thanks
This isn't my subject at all, but I looked to see what seemed to be available as no-one had responded, and found these. But I don't know if they are what you want:
Sefer, B. (2016). Environment related surface phenomena and their influence on properties of Ti-6Al-4V and Ti-6Al-2Sn-4Zr-2Mo: oxidation at elevated temperature and corrosion during chemical treatment.
Modgil, A. (2003). Effects of high speed machining on surface topography of titanium alloy (TI6AL4V) (Doctoral dissertation, University of Florida).
http://etd.fcla.edu/UF/UFE0002846/modgil_a.pdf
. . . and this is a research project; I haven't seen the full text:
Krishnaraj, V., Krishna, B. H., & Sheikh-Ahmad, J. Y. (2016). Study of finish milling of titanium alloy (TI6AL4V). International Journal of Machining and Machinability of Materials, 18(5-6), 634-647.