Hello there. I'm learning new abaqus and I know the questions are easy. But there is no other source for help. I installed the two-layer plates with the '' face to face '' command. When I apply the load to the top layer, the layer moves away from the disk and I cannot get results. When I apply the load to the lower layer, there is no heat transfer to the upper layer. I want to see the heat transmission between layers by applying the load to the upper layer. I'd appreciate it if you could help. thanks...
hi
check the boundary condition u need to set proper boundary so the top layer wont move away
Fabian Dwenger Of course you're telling the truth. I made the network great here to get the solution faster. thank you.
The mesh on your plate is so coarse that any results you get will probably be wrong.
Martin BaekerI know it's big mesh. i did big mesh to save time. but I still haven't figured out the error in the picture. to solve the error that is important to me. I try to fix the boundary conditions, but somehow failed ...
Martin Baeker Whether the mesh is big or small, I keep getting the error. I'm making a simple mistake in boundary conditions, but I can't solve the error ...
- Badges
- Science topic
- Similar topics
- Engineering
- Thermal Engineering
- Thermofluid
- Heat Transfer