Contact experts in Nanostructured Materials to get answers
1,243 views 185 posts
Questions related to Nanostructured Materials
...
04 July 2013 8,390 3 View
What areas of mathematics (e.g.: Probability, Calculus) and science etc. are to be known, in order to develop new mathematics for constructing optimal globally symmetric structures by following...
06 June 2013 2,647 0 View
I can't find the detail method or exact amount for the reduction of graphene through these chemicals. I have searched alot but I have only found the result and effects, but not the detailed...
05 May 2013 5,596 0 View
I am trying to decompose rare earth acetate in oleic acid/octadence/oleyamine. Previous publications suggest that the end product is a white precipitation, but I keep getting a black gel like...
05 May 2013 2,956 5 View
I want to calculate porosity of CrSiN/SiN metallic hard coating deposited on silicon and glass substrate.
04 April 2013 985 1 View
If both then which factor dominates?
04 April 2013 4,204 7 View
Characterization for the B7 banana mesophase.
17 March 2013 4,042 1 View
03 March 2013 426 1 View
Consider the two cases for e-beam lithography, assuming the polymer thickness and particle dimensions are the same: 1) a non-conducting substrate with a 10nm layer of Cr over the polymer 2) a Si...
02 February 2013 8,322 6 View
I am trying to synthesize silver nanorods using the seed mediated growth approach. I was wondering if I could replace CTAB with Sodium lauryl sulfate (SDS), since I don't have access to CTAB. Both...
02 February 2013 3,916 1 View
Admittance of nanstructures
12 December 2012 8,363 0 View
-
10 October 2012 1,090 0 View
Will the blocking/scattering effect of Pb be the same in nanoparticle coated material?
10 October 2012 7,437 2 View
we have prepared Mg doped ceria nanostructures, and characterized by LCR meter for electrical conductivity, at low frequencies the electric conductivity is almost same for all Mg dopant levels but...
01 January 1970 3,927 5 View
We have undoped, 1,2 ,3,4 and 5% Mg doped Ceria nanostructures. in its dielectric results (using LCR meter), the AC conductivity is nearly constant at low frequencies and then increases above a...
01 January 1970 5,668 1 View
01 January 1970 8,722 2 View
01 January 1970 8,591 0 View
Metallic Cu is a good catalyst for catalytic conversion of carbonaceous compounds, where C-C bond should be retained and C-O bond cleaves. A few such reactions are hydrogenolysis of glycerol to...
01 January 1970 9,432 4 View
Within 2nd World Congress on Recent Advances in Nanotechnology we organize the Workshop on Nanostructured Surfaces http://www.rancongress.com/workshop/ The workshop will be held on April 4th,...
01 January 1970 5,247 5 View
Dear colleagues, I am looking for standardized measurement methods in UV-Vis spectroscopy to define optical properties of some nanostructured materials and coatings containing AgNPs and ZnONPs or...
01 January 1970 3,445 2 View
I have prepared 3 Nanostructured lipid carrier formulation with size range froom 90-160nm.What is the best way to prepare FESEM samples for good surface imaging?
01 January 1970 2,765 1 View
Hello everybody I am trying to plot Capacitive current density (mA/cm2) vs. scan rate from cyclic voltammetry. can anybody help me that "How can calculate Capacitive current density (mA/cm2)...
01 January 1970 4,647 5 View
Can there be improvement in structural, surface morphology and compositional properties of films by applying the electric field? Can chemical reactions at the surface be influenced by field what...
01 January 1970 9,928 0 View
Drilling of composite without any post drilling affects is very complicated process in aviation industry, because composites are not isotropic as metals. So we can not use any model that is only...
01 January 1970 2,198 5 View