Satish Kumar Meenakshisundaram

8 Questions 4 Answers 0 Followers

Questions related from Satish Kumar Meenakshisundaram

How to get the parameters for damage initiation in ABAQUS?

I have been trying to simulate a compression test on a Octet lattice structure. And, I want to go till it damages and in abaqus for damage initiation it is asking me to look for strain and stress...

11 November 2018 7,618 0 View

In abaqus my buckling analysis inp file sizes upto 170mb.. is that correct?

Please help with the above issue as I'm getting an error message saying not enough space to write files.

06 June 2018 2,097 2 View

How to set rotational Boundary condition to an A-Arm while it's 3D elements doesn't have any rotational degrees of freedom?

I'm trying to simulate a suspension assembly where A-Arms are my area of concentration. Now, I have to model the A-Arm to have one rotational degree of free (to capture effects of adjustment while...

06 June 2018 6,281 0 View

How to imperfection for each mode in a non-linear buckling analysis in ABAQUS?

Please do suggest a method to calculate imperfection

06 June 2018 6,343 2 View

Buckling Analysis using ABAQUS (Concrete Column)?

I have a problem where I have to model a concrete column around which a steel sheet would be layered. Now, I would like to know whether joining the concrete column and steel sheet with a tie...

06 June 2018 6,157 0 View

How to obtain solution dependent amplitude variables in abaqus?

I'm trying a static riks analysis where i'll need LPF. How can I obtain it?

06 June 2018 7,010 3 View

In a structural analysis of a mechanical componenet, I wanted to add two types of loads on the component at the same step (say, gravity and cload)?

Is the above situation possible in ABAQUS

06 June 2018 9,693 5 View

How to model Bolts between two mechanical components on ABAQUS?

I have a mechanical assembly like such in the attached image. Here, the pink (frame) and the grey (bracket) are to be attached using bolts as in the image. Now to simplify the model I will be...

05 May 2018 3,950 0 View