Saad Waqar

5 Questions 5 Answers 0 Followers

Questions related from Saad Waqar

Using Tangent modulus in abaqus material model properties?

I want to add the data of tangent modulus and its variation with temperature however i am unable to find a way to do it in ABAQUS as there is no direct way to add this data in abaqus , so how am...

10 October 2019 6,149 3 View

During Additive manufacturing simlation type modeling , should we opt for surface type heat flux for moving heat source or body type heat flux model ?

WHile undergoing layered additive manufacturing processes of metallic components the option for moving heat source as flux are surface type and body type? whats the difference and which one should...

09 September 2019 1,807 3 View

An increase in percentage elongation with re crystalization temprature?

For my Steel 316L samples, the percentage elongation is increased with a 1050 degrees heat treatment by aprox 5-8 %, what could be the possible cause

03 March 2019 5,168 4 View

The minimum required number of specimen for a high cycle fatigue HCF test ?

In order to conduct a specific high cycle fatigue test, what should be the limiting criterion for number of high cycle fatigue test samples? i have gone through a number of papers but unable to...

02 February 2019 6,930 1 View

Variation in behaviour of Heat treated Stainless steel hardness?

After undergoing a solution heat treatment (air quenched) and full annealing heat treatment on my stainless steel samples it was observed the hardness of full annealed samples is more than air...

02 February 2019 6,747 9 View