Reema Shrestha

12 Questions 13 Answers 0 Followers

Questions related from Reema Shrestha

How to write a transfer matrix for a beam splitter to trace the output ray angle for arbitrary incident angle?

I am trying to design an optical setup where the arbitrary incident beam passes through a beam splitter where the emergent ray will pass through a convex lens following a detector. How do I find a...

24 October 2022 4,209 0 View

How to calculate power of discharge of DBD plasma?

I have to calculate the discharge power of DBD plasma. I took the data from high voltage probe through oscilloscope. But I'm not sure how to analyze the data and calculate the discharge power. I'd...

07 August 2019 9,664 3 View

How to calculate the maximum vacuum pressure a borosilicate glass can handle?

For a plasma chamber which has to be vacuumed to low pressure, how do I calculate how much vacuum pressure can it handle without the risk of implosion?Is there any mathematical formula for it? The...

30 November 2018 2,253 4 View

How to analyze the FTIR spectra of graphene oxide?

This is the spectra of GO. The peaks are somewhat shifted from where it should have been. There were impurities in my sample but could anyone help me interpret the trough points for whatever my...

15 February 2018 4,768 8 View

How to remove the impurities of Graphene oxide?

Following Hummer's method,I prepared Graphene oxide and the final product was like this in the file attached below. After centrifuging,it looked this way(also attached below). It seemed pretty...

25 January 2018 9,325 6 View

What is the minimum amount of carbon content in graphite that would work for the synthesis of GO?

I am trying to buy graphite powder for the synthesis of GO but in market I get the graphite powder having around 90-95 % carbon content in graphite. Graphite of purity around 99% are a bit...

02 January 2018 2,113 6 View

Queries related to magnetic field effect on plasma discharge

I have some queries regarding the experiment on magnetic field effect on plasma discharge. 1. To conduct experiment on low magnetic field(~0-100 G),which Langmuir probe(i.e. single or double)...

01 January 1970 2,234 3 View

How to make a RF power supply for generating plasma discharge?

We have a single langmuir probe reactor system to generate plasma discharge in lab which works on AC/DC supply. Projects have been done under the system before. Now I'd like to work for RF mode...

01 January 1970 1,989 6 View

Could anyone suggest me some papers on numerical simulation on effect of magnetic field on plasma parameters?

I am trying to search for a topic in plasma for my project and I am quite new to Plasma Physics. So if you could also suggest me on how to start with this topic,it'd probably help me a lot.

01 January 1970 2,443 5 View

How to calculate for the parameters for making a helmholtz coil?

I want to make a helmholtz coil to create magnetic field about 100 Gauss. I tried searching over Internet as well. I will be using 18 gauge copper wire to make coils of radius 15 cm. It'd better...

01 January 1970 9,161 1 View

What is the effect of magnetic field on atmospheric plasma discharge?

There has been many experiments on effect of magnetic field on low pressure plasma and atmospheric jets but has there been any works on atmospheric plasma discharge before? What's the minimum...

01 January 1970 6,030 6 View

How to analyze the optical spectra of Argon jet?

I have optical spectra data for atmospheric pressure Argon jet and below is the graph for the section of Argon I lines. But I am not sure how to start analyzing. I found a pdf online for NIST...

01 January 1970 8,241 0 View