3 Questions 2 Answers 0 Followers
Questions related from Rallapalli Pradyumna
While measuring distortion of commercial plastic injected components, the warpage/distortion is measured as maximum deviation at the tip of the injected part, as compared to its nominal value...
22 September 2015 6,471 1 View
In the process of investment casting, either silica or alumina based mixes are used as injected ceramic cores to provide complex cooling passages in the casting. For low temperature DS (direction...
21 September 2015 5,945 3 View
Parameters used in the injection molding process, such as temperature, packing pressure, flow rate, etc. can be quantified. " Mold Constraint " is increasingly being seen as a major factor...
14 September 2015 476 2 View
