Parag Chaware

8 Questions 14 Answers 0 Followers

Questions related from Parag Chaware

Y+ value in porous zone while modelling flow through porous media ?

I am modelling a flow through porous media using ANSYS Fluent. The flow through porous media is assumed to be laminar. Shall I need to check y+ value in the porous zone also?

09 September 2018 7,851 6 View

How to Determine the amount of heat flux while imposing UHF conditions ?

I am simulating a pipe flow using water as working fluid under Uniform Heat Flux conditions. The ultimate aim is to calculate Nusselt number in laminar and turbulent regime of the flow. I am not...

04 April 2018 2,255 3 View

How to calculate vorticity in the cylindrical coordinates in FLUENT if you have solution in cartesian coordinates ?

I have a FLUENT case of pipe flow. 'X' is the axial direction. I want to plot the vorticity contours in r and \theta plane. How to convert x y and z vorticity to z,theta and r vorticity componenets

08 August 2017 2,653 5 View

How to calculate u' ( Fluctuating component) in FLUENT?

I am working on a LES case in ANSYS FLUENT. I need to calculate u' i.e. the fluctuating component of the velocity. How to get the data about u' in FLUENT?

12 December 2016 4,336 0 View

What d you mean by Delta X+, Delta Z+ in grid requirment of LES?

Large eddy simulation grid requirement mention about Delta X+ = 100, Delta Z+ = 30 and y+ = 1. Y+ is known but what do you mean by Delta x+ and Delta Z+, x is streamwise and z is spanwise directions,

07 July 2016 6,274 4 View

Is LES model suitable for simulating transitional flow in a pipe?

I am trying to simulate transitional flow in a smooth circular pipe using Ansys FLUENT. Is LES is suitable for transition flow modeling? if yes, which SGS model can capture the transition behaviour?

05 May 2016 9,666 9 View

Do we need to check the y+ values for SST K W turbulence model during post processing and if yes, should the y+ value be `1’ everywhere on the wall?

In SST k omega model the flow is resolved up to the wall. For this the y+ =1. However, in some cases where the solution is converged and showing fairly good results, the y+ values...

02 February 2016 518 13 View

How to calculate fluctuating velocity components (u' v' w') for turbulent flow in FLUENT?

I am trying a case in FLUENT where I need to calculate fluctuating components of the velocity. I RSM model for capturing turbulence. Can you suggest any method to get these components

01 January 2016 6,921 8 View