Muhammad Farhan

8 Questions 1 Answers 0 Followers

Questions related from Muhammad Farhan

Why the von misses stress not coming back to zero, if the member has been yielded ? Under Seismic Analysis?

I have performed the seismic analysis on steel structure. After that some parts have been yielded and some are not. Now, in case of yielding, the von misses stresses are not coming back to zero?...

13 January 2023 7,882 1 View

Is it possible to use connector to joint one rigid body with deformable body in ABAQUS ?

I want to join one rigid body with deformable bodies with connector elements in Abaqus. And then I want to apply dynamic load to the rigid body node. How it could be done? Please help !

11 December 2022 5,963 1 View

How to use Large Mass Method for Seismic Analysis in ABAQUS CAE?

I want to perform Direct Integration dynamic implicit analysis on structure using Large Mass method. As my structure is rested on Spring/Connector elements. Now i want to connect the 2nd node of...

01 December 2022 4,620 0 View

How to cut the real Earthquake Acceleration Record at some time interval to use for seismic analysis?

How to cut the real accelerogram earthquake record at some time interval to ensure that the maximum effect of the complete earthquake record is achieved by cutting the record up to some extent?...

21 November 2022 7,602 1 View

I am solving the problem in Abaqus CAE by using Cartesian connectors but I get the following warning message. Solution?

***WARNING: AT LEAST ONE OF THE NODES OF CONNECTOR ELEMENT 1 (ASSEMBLY) DOES NOT HAVE ANY MASS ASSOCIATED WITH IT. THIS COULD LEAD TO EQUATION SOLVER ISSUES (ZERO...

13 November 2022 2,384 0 View

Solution Convergence error in Abaqus CAE Dynamic Implicit analysis. How to resolve this error?

I am performing the earthquake analysis on bridge structure in ABAQUS CAE under Dynamic Implicit step. I am getting the error as shown in the picture attached. Please see the attached picture of...

03 November 2022 4,426 3 View

What is the Spectral Matching (range) requirement in Japanese Code?

Spectral matching between the design spectrum and the response spectrum of a selected ground motion record is required in most codes. However, the period range for spectral matching varies among...

02 November 2022 9,232 0 View

Why my Hysteresis loop shape is irregular? I used the Kinematic Hardening behavior using half cycle data in connector in ABAQUS. What's the reason?

The simple bridge simulation was performed in ABAQUS to evaluate the seismic response using Lead Rubber Bearings. The bearings were modeled using connector elements in Abaqus. I tried to enter the...

13 October 2022 571 1 View