Mohammed Shehadah

4 Questions 8 Answers 0 Followers

Questions related from Mohammed Shehadah

How to make the cohesive element in abaqus act like a glue instead of acting like a gum?

I am modelling a concrete and a FRP that are connected together with a cohesive element on abaqus and my aim is to study the debonding. The weird thing that is happening that instead of the...

04 April 2019 3,330 3 View

A concrete block is modelled with FRP sheets with tie constraint the FRP is pulled 10mm but the way it deform is wrong how can I slove this proplem ?

In the first figure you can see how this model is loaded in the second figure the deformation is shown.The loading is just a boundary condition of 10mm and connection between FRP and concrete is...

22 March 2019 8,591 3 View

I am modelling a concrete block that is supported by FRP sheets but the problem I am having is that the stresses are not symmetric ?

I am modelling using Abaqus a concrete block with FRP sheets on its top and bottom the FRP sheets are pulled by a point load at the centre the connection between FRP and block is tie the stresses...

23 February 2019 492 9 View

Why is the FRP sheets that are used to reinforce a simply supported besm are not loaded?

I am modelling a simply supported reinforced concrete beam with FRP sheets under it the connection between beam and sheet is adhesive agent the problem I am having is that the load is not...

23 February 2019 6,815 7 View