7 Questions 2 Answers 0 Followers
Questions related from Krishna Kashyap
If I take a 200L Fuel tank of a commercial vehicle as shown in the image which has Say X, Y & Z as its primary dimensions, Is there a way I could tell if we would need baffles or not?
08 August 2019 8,067 2 View
As shown in illustration, I have a pipe with details listed below and it is clamped at both ends. Clamps are tightened by applying a torque of 15Nm. How could i find out if the support provided...
07 July 2019 3,090 4 View
I have two rectangular plates with two holes vertically, separated by a distance of 65mm. While fastening them with help of bolts & nuts using a standard required torque tighter, they are...
05 May 2018 4,961 0 View
Example:- In CAD setup: I have a Chassis frame which has a bracket mounted on to and this bracket is holding a mass of certain number of kilograms with help of straps.. Similar to a fuel tank...
02 February 2018 2,119 4 View
I am working on an industrial wire mesh which could essentially function as a cover against flies and I would like to run modal analysis on this mesh which is welded to the frame (Just like a...
01 January 2018 2,611 5 View
Which is the best way to predict freezing pattern of a liquid? For example, I have water in a tank and I would like to find out its freezing pattern based on its geometry. Please provide your...
01 January 2018 3,403 3 View
How will electrification of vehicles affect the engineers working on exhaust systems? Engines? Diesel exhaust fluids or Adblue systems?
11 November 2017 4,104 3 View