Khairil Hafizi

6 Questions 2 Answers 0 Followers

Questions related from Khairil Hafizi

Why pressure at the border of Interface between static and rotating cell zone different?

I have a problem regarding the interface between a rotating and static cell zone. Which settings do i need to adjust in Fluent to have a correct simulation? The case is pretty simple. I have a...

10 October 2016 8,052 6 View

Why fluent unable to compile udf codes?

hello everyone,I faced problem to compile my udf as shown below,I dont know what caused the problem in my udf codes until fluent unable to compile it. I also try to compiled other udf and it goes...

09 September 2016 6,575 6 View

[ANSYS meshing] How to setup unstructured y+ boundary layer distance for 2D airfoil.?

Hi Everyone, could someone tell me how to set first layer distance from the 2D airfoil surface.? I am doing simulation for 2D airfoil.I'm trying to do a simulation of a wing that is both plunging...

07 July 2016 3,709 0 View

How to eliminate error "Update-Dynamic-Mesh failed. Negative cell volume detected" in Fluent?

Hi everyone, I am doing aeroelasticity simulation for 2D airfoil.I'm trying to do a simulation of a wing that is both pluging and pitching. I have created 2 types of mesh using GAMBIT...

06 June 2016 7,496 5 View

FLUENT-preview mesh motion problem.?

Hi everyone I am simulating a 2D airfoil pitching and plunging motion simulation.I run the simulation in fluent by compiling the UDF .c file and set the airfoil as the rigid body and it adjacent...

06 June 2016 930 3 View

How to export 2D meshing from ICEM-CFD to static structural in ANSYS WORKBENCH?

Hi I am doing aeroelastic simulation on 2D airfoil.the method im trying to use is 2 way Fluid structural interaction..i have done the meshing in the ICEM-CFD.I faced problem to export out the 2D...

04 April 2016 7,772 2 View