Emon Barua

7 Questions 15 Answers 0 Followers

Questions related from Emon Barua

How reactive camphor is?

I am looking for a porogen which is non-reactive (inert) in nature. I want to use camphor as a porogen. So I want to know how reactive camphor is?

10 October 2016 316 3 View

Is retrieving data from solution possible?

Hello everyone, I need to retrieve the maximum absolute value of deformation/displacement in y-direction(Uy max) from the solution using *GET command and store it as a parameter. Any suggestions...

04 April 2015 8,498 2 View

Can two areas modeled in different cs be displayed at a time in a single wokplane?

Hello everyone, I have two different rectangles modeled in two different cs in ANSY MAPDL. But while displaying in the workplane, the orientation of any of the one cs comes at a time and...

02 February 2015 3,859 1 View

Why have I received an error message in ANSYS: "Degree of freedom limit exceeded".?

Hello everyone, I am trying to model and analyze a Chiral Graphene Nanosheet in ANSYS MAPDL. I am done with the modeling and boundary conditions part. But when I go for solution, I am stuck with...

01 January 2015 4,316 12 View

How can I transfer a geometry from one coordinate system to the other considering node positions in ANSYS MAPDL?

Hello, I have attached a picture of a geometry with nodes created in ANSYS MAPDL. As shown in the figure, I need to transfer the entire geometry to the coordinate axes shown below with Node no.21...

12 December 2014 8,030 16 View

Can we assemble two different components in Ansys Mechanical APDL?

I need to assemble two different (already meshed) machine components in Ansys Mechanical APDL.

12 December 2014 1,954 2 View

How to perform bending/rolling of a sheet in ANSYS APDL?

Hello. I am trying to model a Carbon Nanotube out of a Graphene sheet. I have already modelled the graphene sheet in Ansys (Mechanical APDL), which now I need to roll and connect one end...

12 December 2014 5,939 1 View