Chunying Wang

10 Questions 12 Answers 0 Followers

Questions related from Chunying Wang

Comsol, mechanical damping, not convergence?

When I compute a piezoelectric transducer in a water domain, the solution works well and convergence. However, when I add mechanical damping to the piezoelectric material and keep others all the...

05 May 2017 8,710 1 View

Howto calculate the thickness resonace frequency of a 1-3 composites?

I want to calculate the thickness resonace frequency of a 1-3 composites (Fig). In order to reduce the computation, only one element is used(Fig). I am wondering how to set the boundary condition...

04 April 2017 8,474 2 View

How to calculate the output electric power of transducer with Comsol?

When I apply 1V on the PZT disc, I want to know how much electric power transfer into mechanical power, how much is consumed by itself?

07 July 2016 7,561 1 View

Anybody have experience on simulate the transducer fabricated by 1-3 composites(piezoelectric rods embed in epoxy)?

I simulate the transducer model by comsol. However, the results are weird for the far field level, what I want to know is if it is not easy to simulate this composites? The files are attached.

07 July 2016 4,064 3 View

Nonuniform acoustic field is generated by simulating the transducer,why?

Hi, when I simulate the 1-3 piezoelectric composite transducer, the generated acoustic field is nonuniform. the acoustic field picture is attached, I want to know why？

06 June 2016 7,507 9 View

Comsol, When I simulate the impedance of 1-3 piezoelectric composite, how to remove the resonance mode of polymer?

Hi, all I want to simulate the impedance of 1-3 piezoelectric composite using piezoelectric device interface, however the results resonance peaks always couple with polymer vibration, I don...

05 May 2016 1,846 1 View

Why not the far field calculation does not work in Frequency-Domain, Perturbation ?

Hi, I simulate the transducer performance under pre-stressed, and I reference the template "tonpilz transducer prestress" in the library. Far field pressure works under frequency domain, but I can...

05 May 2016 9,072 3 View

How to constraint the transducer by comsol?

hi, when I simulate the transducer by comsol, I found that the constrain position effects the impedance spectrum significantly, I want to know the proper restrain which has little influence...

04 April 2016 6,172 4 View

The model heat transfer established by comsol can not convergence?

The heat transfer model convergence at first, but when I increase the electric potential or calculation time, it turns do not convergence, I want to know why, wrong boundary condition, or...

04 April 2016 698 5 View

How to simulate the band width and sensitivity of transducer using Comsol?

Hello, everyone, using far- field calculation to compute band width, however I don not know how to postprocess the data obtain from the polar plot data? Thank you all!

04 April 2016 2,967 2 View