Ankush Choudhary

6 Questions 22 Answers 0 Followers

Questions related from Ankush Choudhary

For contact stress analysis in gears, which stress in ANSYS represents contact stress, whether to use Von mises stress or contact pressure?

In ANSYS we get different stresses for gears under contact. So which stress should be used to compare with Hertzian contact stress.

03 March 2019 6,629 6 View

Which algorithm is used by commercial FEA solvers for Topology Optimization?

These commercial FEA solvers do Topology Optimization after FEM Simulation but on what basis they remove elements from the model.

01 January 2019 7,511 11 View

In ANSYS 19.1, SpaceClaim is not working, whereas APDL and Work bench are working fine. Does anyone faced a similar situation?

The SpaceClaim design modeler is not working and It does not show any type of error also. In Workbench, It shows a message that starting SpaceClaim but does not start.

06 June 2018 1,656 6 View

Which Finite element tool is best for additive manufacturing analysis?

I am using ANSYS but I have heard that ABAQUS and NASTRAN results are far better than ANSYS.

02 February 2018 7,955 22 View

How to use GMAW welding process for additive manufacturing?

3 D printer and GMAW welding both uses consumable wires then why can't we use GMAW process for additive manufacturing.

02 February 2018 441 11 View

How can we measure the wire feed speed in Submerged Arc Welding during welding operation?

In SAW welding control panel voltage, current and trolley speed is there but wire feed speed is not there, I want to know wire feed rate also.

05 May 2016 5,857 7 View