WSN nodes can we use in Internet of Things
Yes, you can use wireless sensor nodes in IoT. The protocols which you use in WSN like Zigbee, Blutooth, BLE etc. can be used in IoT. Networking concepts and protocol alone differs in IoT.
Dear Sir,
Thank you for your valuable reply.
How do we calculate the power consumption and energy consumption in wireless sensor network
04 May 2018 8,209 0 View
What is context aware Internet of Things? How can we adopt context in IoT architecture? Is context as middleware service for IoT?
03 April 2018 3,302 2 View
Can we do the cluster head selection using optimization technique for Internet of Things?
11 December 2017 3,801 3 View
Received signal strength calculation (RSSI) in cooja code
09 October 2017 1,218 1 View
What ways we can provide the efficient solution for energy efficient Routing for Internet of Things ?
05 June 2017 9,927 0 View
which is the better tool for RPL routing in Low power and Lossy Networks
05 June 2017 2,177 2 View
how do we get the node information in RPL protocol using cooja simulator
02 March 2017 5,144 2 View
what is the beauty of RPL routing protocol in Internet of Things?
02 March 2017 8,353 4 View
Contiki Cooja not showing stats on Collect View
11 December 2016 1,165 0 View
What are the Research Challenges in IoT?
10 November 2016 4,831 2 View
Is there a powerful system for the security of the systems distributed on IoT systems?
02 March 2021 3,858 10 View
The Lanthanide contraction which is the decrease in ionic radii of the elements in the lanthanide series from atomic number 57, lanthanum, to 71, lutetium, is due to poor shielding of the 4f...
01 March 2021 2,272 4 View
Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...
01 March 2021 9,332 6 View
Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...
01 March 2021 2,327 1 View
Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...
28 February 2021 400 1 View
I am working on developing a micromechanical FE model for predicting kink-band formation in UD composites. To model matrix plasticity, which model, out of Concrete Damaged Plasticity and...
28 February 2021 5,415 1 View
I am working on TiO2 composite material and the results of XRD have a lot of small/junk peaks and while I apply a smooth filter in Origin then the other characteristics peaks disappear so anyone...
26 February 2021 8,183 3 View
Does data from contact tracing help in establishing patterns of behavior and social interactions that lead to infections? There are cases here in the Philippines where patients have no travel...
25 February 2021 9,002 13 View
Hi, everyone I'm working on a privacy-preserving algorithm that will apply to IoT devices. So, I need to measure the power consumption by implementing this algorithm. Any suggestion, advice,...
25 February 2021 8,749 6 View
Im looking for any papers, reports,articles, links etc on information on How vulnerable is water and wastewater infrastructure to cyber terrorism in an age of IoT.
24 February 2021 2,750 4 View