Hi,
I am working on an aqueous battery. The anode material is Lithium Titanium Phosphate (LTP) and cathode material is LMO. I am working on the CV curve of LTP. The current collector I used is carbon cloth. The active slurry consists of active material: super P: PVDF (mass ratio is 8:1:1). The attached figure is the CV curve I got. The scan rate is 0.01V/s. Ag/AgCl as reference electrode ane Pt as counter electrode.
I have some questions for the experiments.
1. Do I have to prepare the slurry in argon?
2. Can I use the ethanol to mix with slurry to coat the slurry and then remove the ethanol under vacuum at 100 degreeC for 12 hours?
3. The LTP was purchased from TCI. I think it should be OK for the chemical.
Can anyone give me some suggestions?
Thanks a lot,
Chongjie
- Badges
- Science topic
- Similar topics
- Engineering
- Electrical Engineering
- Electrodes