Why PLE peak Position of ZnS Nanostructures changes on varying excition wavelenght?

Huma Habib @Huma_Habib

12 December 2018 0 5K Report

Actually, i am working on a device fabrication and i need the answer of this question.

Badges
Science topic

I need JCPDS file of LSFCO nanomaterial. Can anyone provide me?

Require for Rietveld refinement in XRD.

08 August 2024 3,081 2 View

How do you decide an optimal AC amplitude for non-faradaic electrochemical impedance spectroscopy?

I work with planar interdigitated electrodes (IDEs). The finger width and the spacing between the fingers are 5 micron. The surface of the IDEs is coated by a non-conductive polymer layer...

16 July 2024 5,031 1 View

Can someone help me to model a core-shell nanostructure in GDIS and subsequently prepare the fdf file for using in SIESTA?

I am very new to the material modelling in GDIS. So, I want to learn how to model a nanostructure specifically core-shell in GDIS.

28 June 2024 5,224 0 View

Which solvent and substrate is found to be best suited for deposition of electrodes with MXene ink?

Suppose we have dried MXene slurry (Ti3C2Tx), then the combination of which solvent (in which this dried MXene slurry powder will be mixed, subsequently forming the "ink") and corresponding...

13 June 2024 5,763 0 View

Can anyone explain how to determine degassing temperature and time for biosynthesized nanomaterial for BET analysis?

I have also attached TGA and DSC analysis of biosynthesised nanomaterial.

30 May 2024 1,565 1 View

Can an activated carbon be referred as nanomaterial?

Activated carbon are nanomaterial itself?

20 May 2024 8,832 3 View

How to detect the concentration of silver ions in a nanosilver solution?

Hello, I'm Sam. Background: I'm a researcher at a nanomaterial company in Taiwan, and recently I've encountered some problems that I'd like to seek help with. The company aims to determine the...

14 May 2024 4,393 4 View

Why my simulation of Mixedmode is always wrong?

I want to make n-type and p-type GaN devices as inverters and simulate them by Mixedmode. However, it always turns out to be wrong. With the warning: no solution possible. I want to know what the...

12 May 2024 4,377 1 View

Has anyone used the MEMS and Nanotechnology Exchage (MNX) foundry service?

I have been trying to contact them for about 2 weeks now and I have received no response. I am wondering if they are still active. If not, could anyone suggest a similar foundry service to do some...

12 May 2024 2,100 0 View

What is the best material contact to use on cubic boron Nitride film on a yellow diamond substrate for Van der Pauw measurement?

Researchers studying the electrical properties of cubic boron nitride (cBN) films on diamond substrates encounter several challenges. One major issue is achieving high-quality deposition of cBN...

03 May 2024 8,448 0 View