Why people does not use lanthnum strontium manganites for magnetic tuneable devices??

20 September 2017 1 9K Report

why people does not study magnetic dynamics properties of LSMO nanopaticles even it has good magnetism at room temp. this properties leads to fabrication of microwave magnetic devices

Henry Clemente

Too difficult to produce unless you have a simple method to make them

More Ravi Kumar's questions See All

Should I remove an item from a scale to raise Cronbach's alpha and McDonald's omega or is it better to leave it if they are both over .7 already?

Hello! I have this scale which had 10 items initially. I had to remove items 8 and 10 because they correlated negatively with the scale, and then I removed item 9 because Cronbach's alpha and...

01 August 2024 4,606 7 View

What is the relationship between the threshold voltage and the device's noise performance, particularly in terms of flicker noise and thermal noise?

The threshold voltage (Vth) of a MOS device plays a crucial role for its operation. At the same time, noise is an intrinsic factor. So how noise (flicker or thermal) change with the change in...

29 July 2024 3,246 0 View

What is the solvent system required to run tlc for calixarenes?

If you don't understand my question let me know

21 July 2024 563 1 View

Are there always been barcodes, apapters and primer sequences in the FASTQ files of NGS?

Hello researchers, Sorry for my stupid question. I am learning the QIIME2 workflow for analyzing some 16s amplicon NGS fastq data. I found a very nice paper with data and code public available...

20 July 2024 5,405 2 View

Sample size for qualitative study?

I am working on scale development in behavioral finance by undertaking a mixed-method approach using the exploratory sequential design. The phenomenon has diverse meanings in existing literature...

20 July 2024 9,153 11 View

How to determine LOD values?

I am performing fluorescence experiments using a ligand to detect metal ions. I want to determine the Lowest Detection Limit (LOD) using the formula LOD = 3σ / K. However, I'm uncertain about...

19 July 2024 1,086 1 View

How to convert available phosphorus to total phosphorus?

I need to convert Available phosphorus into total phosphorus

18 July 2024 6,799 3 View

Can it is possible to find the cleaved sequence when a protein cleaved by a heamaglutanin protease (HA/P) by any bioinformatics tools?

Bioinformatics tools like peptide cutter

15 July 2024 6,453 1 View

Can we progress towards defining obesity based on body fat content?

The burden of obesity is enormous. The greater challenge lies in accurately diagnosing obesity at the right time, reflecting the true increase in visceral fat. BMI may not accurately represent...

14 July 2024 8,771 4 View

How to use stress and displacement results from 1st stationary simulation as initial conditions for 2nd eigenfrequency simulation in COMSOL?

Dear All, I am trying to define the dispersion curves of a periodic unit cell in COMSOL Multiphysics with prescribed displacements. I am using two separate studies: - Study 1: Stationary, with...

13 July 2024 7,855 1 View

Difficulty with permittivitt and Magnetic Permeability Calculations?

Difficulty with permittivitt and Magnetic Permeability Calculations Hello everyone, I have all the parameters related to the calculations of the permittivitty and magnetic permeability...

30 July 2024 5,206 1 View

Please, whoever has this part of the book, send it to my email, because I need it and cannot buy it?

Strontium: Source, Occurrence, Properties, and Detection Chapter First Online: 05 June 2019

25 June 2024 2,198 0 View

I wanted to know whether the magnetism of iron oxide nanoparticles will interfere with electromagnetism in TEM and influence image formation?

I wanted to take tem images of my magnetic nanoparticles prepared using iron. It has a magnetic susceptibility below 10 emu/g. Whether this will interfere with the electromagnetic lenses of TEM...

14 June 2024 5,163 4 View

What can we get from ZFC/FC curves and what is the reason behind?

We have measured the ZFC/FC curve under 100Oe, there is splitting happens and there is another turning point happens to around 25K, why it is increased again with decreasing temperature?

11 June 2024 9,603 1 View

Why should we expect pollution management markets to lead us increasingly away and away from pollution-less markets?

Since 1987 WCED report "Our Common Future" pollution has been increasing, not decreasing, as no pollution reduction markets have been set up yet to transition towards pollution-less markets, which...

03 June 2024 5,550 6 View

Which books should i read to learn the basics of Magnetic Nanoparticles?

I want to learn the Magnetism of nanostructured materials in very deep. Please suggest me some books , if anyone of you have suggestions.

18 May 2024 7,415 1 View

Is there a direct connection between zero core reluctance and zero leakage flux?

I have seen that some lecturers claim the leakage flux of a transformer will automatically become zero in case it has an ideal iron core. I want to say NO! This is correct for a system with a...

03 May 2024 4,010 14 View

How can I perform constrained SDFT of a material e.g fcc Ni? Can someone tell me what syntax should I give in my input files?

Recently I am studying on Exchange interaction and Magnetic force theorem(MFT) .. there the basic idea of MFT is we have to rotate the exchange-correlational (xc) potential by assuming that within...

29 April 2024 8,568 0 View

Why does the Rotilabo MH 20 Heating Plate show ALL 6?

Hey there, for an experiment I am using the heating plate. I want to heat a glycerol bath to 120°C. The magneting stirring is off. Temp set at 120°C. Now, as the temperature nears 120°C (e.g....

17 April 2024 2,726 3 View

Magnetic Skyrmions in Chiral Molecules?

What is the best computational package other than VASP for the calculation of magnetic Skyrmions in chiral molecules?

10 April 2024 3,050 0 View