Which is the most convenient manufacturing software for Additive Manufacturing?

Which tools can be used to generate machine codes for additive manufacturing?

02 March 2021 7,220 2 View

How to Eliminate cosine error and abbe error in LASER measurement system(for example Rhenishaw XL80)?

I like to do project in laser measurement system. My objective is to eliminate or reduce the cosine error, abbe error in Laser measurement system. I have Rhenishaw XL80 system. Please tell the...

28 February 2021 4,890 3 View

How to measure angle between laser travel path and machine axis in Laser Measurement system?

25 February 2021 1,987 3 View

What software programs can directly simulate Additive Manufacturing Directed Energy Deposition (DED)?

I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....

24 February 2021 4,428 3 View

How to differentiate the economic productivity in agriculture and in manufacturing sector?

Most of the references I found were on the economic productivity in agriculture but very limited application in manufacturing sector. I would appreciate if anyone could share the references on...

15 February 2021 8,342 7 View

How to increase bacterial concentration of DNA from Laser capture microdissection samples?

I used laser capture microdissection, selected specific bacteria presented in ethanol-fixed slides. And DNA was extracted by Qiamp mini kit. The problem right now is we have pretty low...

09 February 2021 3,908 2 View

How to measure cosine, abbe, deadpath errors?

Dear sir, How to measure cosine, abbe, deadpath errors. I know cosine error, abbe error, deadpath error occurs in laser measurement. But how i can identify the cosine error value. Is any separate...

03 February 2021 4,878 4 View

How to apply graphene oxide on an gold electrode?

Dear Fellows, now it is the time to push graphene applications further in terms of easy and low cost production surroundings. Thus I recently dived in the materia and I am facing tons of papers,...

02 February 2021 6,284 2 View

Which method is preferable for cutting the nanocomposites?

Which of the methods like water jet cutting, diamond cutting, laser cutting, etc. is more suitable to cut the carbon nanotubes reinforced epoxy composites into test sample to ensure the clean...

29 January 2021 1,354 5 View

Where is the active point of VCSEL?

I am now working on the coupling between vertical-cavity surface-emission laser(VCSEL) and waveguide. However, the window design for laser emission is larger than the waist of Gaussian beam...

27 January 2021 8,318 1 View