Which is the best for clear zone test?

More Shalini Manjunathan's questions See All

Name some indexed journal?

Hi Any one refer some indexed journal name other than Elesiver and Science direct for research article in biotechnology Thank u

05 June 2015 9,431 8 View

Name some funding agencies ?

Hi Good Morning, Any one guide me some funding agencies other than DST, DPT, UGC for Pursuing Ph.D in Biotechnology

04 May 2015 9,085 1 View

Which solvent should I use to dissolve polythene?

Hi can anyone give me some idea on how to dissolve polythene powder in solvent.

02 March 2015 9,254 13 View

Hello I want a methodology for synthesis of nano parcticels from microorganisms anyone please help me?

Hello I want a methodology for synthesis of nano parcticels from microorganisms anyone please help me

11 December 2014 4,182 2 View

How to isolate free radicals from Fungus?

Hi please anyone gave the methodology for isolation of free radicals from fungus

11 December 2014 5,697 3 View

Regarding Identification of microorganisms

Good Morning, I have lot of unknown micro-organisms , if i go for 16sr RNA means it require lot of amount, so far that to minimize i need alternative way for microorganisms identification. so any...

09 October 2014 8,172 3 View

Can anyone help with a methodology for polythene degradation?

Good evening Can anyone please help me to degrade low density polythene by using microorganisms with a clear zone test?

08 September 2014 1,659 3 View

Methodology

Good evening Hi anyone pls help me to degrade Low density polythene by using microorganisms with clear zone test

06 July 2014 3,772 0 View

Any one help me to get Tributyrin agaar (OR) Sprit blue agar?

Good Evening I am in need of Tributyrin agaar (OR) Sprit blue agar is it possible means , please provide me, it help my research Thank you

01 January 1970 479 4 View

How to calculate CCS for Sodiated adduct ions and Multiply Charged Ions?

I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...

08 August 2024 8,329 0 View

Inquiry on Maximum Nucleic Acid Volume for 2.5 mL Liposome Solution?

I am currently working on a project involving liposomes and need to determine the maximum volume of siRNA that can be added to a 2.5 mL liposome solution with a total lipid concentration of 10...

30 July 2024 6,420 1 View

How can I use DFT-D3 correction ( Siesta version 5.0.1)?

Dear Siesta Users, I installed Siesta 5.0.1 and I want to use Grimme's D3 correction. According to the 5.0.1 manual, I could use a few parameters to include the D3 correction in the...

27 July 2024 5,748 0 View

EDC carbodiimide and NHS easter 's half life among different pH?

It has been long known that EDC carbodiimide and NHS easter's half life agains hydrolysis are highly related to pH. However, very surprisingly, not yet found a paper giving a table/chart of their...

25 July 2024 8,738 0 View

Comparison of Methanol and ethanol treatment on collagen based scaffolds?

Kindly share a research paper that explains the effect of Methanol and ethanol treatment on collagen based scaffolds. How it increases porosity and swelling. Kindly help me find a paper. Thank you

24 July 2024 3,937 0 View

Mechanochemistry: ball to powder mass or ball to powder volume?

I run mechanochemical reactions that involves the use of a large amount of catalyst (1:1 molar ratio to the reactant). When I try to understand the effect of amount of catalyst on the reaction, I...

23 July 2024 9,938 1 View

How to eliminate the carry-over effect in GC-MS/MS system?

Hi, I am a PhD student working at Jagiellonian University, Faculty of Chemistry. My work is related to the development of new analytical methods for the quantification of short-chain fatty acids...

22 July 2024 5,492 6 View

Is it possible to manufacture polypropylene sheets using a biaxial process?

I know that films and other low-thickness laminated products are produced using biaxial orientation, but is there something similar for sheets with a thickness of around 6 mm? Or are they...

21 July 2024 1,559 1 View

MDCI module in Orca software?

Dear Researchers, My question is associated with the "MDCI" method in Orca. Please let me clarify my question using a simple example: Suppose we are going to perform CBS extrapolation using "!...

21 July 2024 1,632 0 View

What is wrong with my input file?

im studing gaussian 16 with reading paper about I-131 Metaiodobenzylguanidine in the paper "In a similar vein, nuclear magnetic resonance shielding values were investigated using the widely...

16 July 2024 6,040 4 View

Dr. Senthilvel Vasudevan

Hi,

For your question, kindly refer the following links:

http://jocpr.com/vol5-iss8-2013/JCPR-2013-5-8-122-127.pdf

http://www.rjpbcs.com/pdf/2014_5(3)/[144].pdf

http://www.academicjournals.org/article/article1380286813_Geweely%20and%20Ouf.pdf

http://journals.tubitak.gov.tr/biology/issues/biy-11-35-5/biy-35-5-3-0901-9.pdf

http://www.dhakai.com/botany/journal-june2006/articles/005.%20MR%20Khan.pdf

Shalini Manjunathan

Good Afternoon sir thanks a lot foour r ykindly reply