What studies are known for the calculation of doubled wells and wells with unloading the bottom of the filter column? (page 112-116)
The increase in plant biomass during feeding depends on the intensity of chlorophyll photosynthesis, and the NDVI is too coarse for this index - it poorly follows the high chlorophyll content and...
10 December 2019 4,192 8 View
Improving the efficiency of use of materials reduces the "material use" in 2 times the base materials, due to the effect of doping materials SWCNT - changes in the properties of materials when...
30 December 2018 4,913 3 View
Hello, If i am doing a buffer exchange for an antibody of 1mg/mL, does the elution lose protein in the process of buffer exchange? For example, if i flow through 500 uL of 1mg/mL sample, and...
03 March 2021 6,299 3 View
Hi, I implemented a code to gabor filter cifar10 data but the images after being filtered and stacked are not clear like the original images. I think the problem is in the way I am using the...
03 March 2021 6,317 1 View
03 March 2021 5,360 2 View
I analyzed flavonoid total spectrophotometry, the procedure as below: 2 ml supernatan added 5 ml dd.H2O, then added 0,15 ml NaNO2 5%, 5 minutes later added 0,15 ml AlCl3 10%, After 6 minutes,...
01 March 2021 6,722 1 View
Hi, everyone. I'm a starter to write a paper by Latex. But I have some difficulty using it. I'm writing the paper with 2 columns. And, there is one figure that occupies the 2 both-sides. I want to...
26 February 2021 3,738 3 View
In Finite element software like ANSYS , there is difficulty in obtaining direct results of twisting of concrete members because SOLID65 which is the unique element designed to represent concrete...
26 February 2021 3,806 2 View
Looking for the quantity of cement, sand, and gravel of footings and columns. Thank you!
25 February 2021 3,092 2 View
I have set up a qPCR run on MxPro with SYBR green and ROX as a reference, however, when I go to the analysis section the program seems to only collect data for the dissociation curves and not the...
25 February 2021 8,039 1 View
I am trying to analyze lipase using the reverse phase-HPLC C18 column. In the literature, 0.1 % TFA was and 60% ACN was used. Can I use TCA in place of TFA? If any other methods are available to...
25 February 2021 2,388 3 View
I used EdgeR to get the list of DEGs (differentially expressed genes) from my liver RNA-seq experiment. I have done the gene overrepresentation and GSEA based pathway analysis. I am currently...
23 February 2021 8,969 1 View