What problems when connecting DC-DC converter output in series?

João Lucas de Souza Silva @Joao_Lucas_De_Souza_Silva

01 January 2019 0 3K Report

Assuming I have 3 DC-DC boost converters, and I connect the three in different sources. The output is connected in series and in a load. How will the behavior be? Are there papers for this?

Badges
Science topic

More João Lucas de Souza Silva's questions See All

How to control power optimizers connected to any photovoltaic inverter within the specifications?

I would like to know how the control of optimizers in series is done, therefore I understand it is necessary to keep the DC current equal for all and to do the MPPT. Does the DC link of the...

11 December 2018 4,399 1 View

Which protection circuits do you use for current and voltage sensors?

I will use sensors with up to 20A for current and 220V for voltage.

08 September 2018 4,810 0 View

What behavior to connect two cascaded MPPT?

If I connect two DC converters to a PV array, both of which have MPPT control, what would happen? Is there any work on this? PV -> [DC convert (1-MPPT)] Optimizer -> [DC convert (2-MPPT) - > AC]...

07 August 2018 3,561 0 View

What phrase from scientists most inspired you?

We always have a key phrase about the scientist we most admire in each area, what is yours?

04 May 2018 5,933 11 View

Discussion: In your opinion, what is the most important invention for humanity in your area? Why?

This question aims to discuss and raise opinions on scientific inventions in the most diverse areas of importance to humanity. Write about your area of study and what inventions were relevant to...

04 May 2018 693 1 View

The number of citations is a quality metric for a paper? What metrics do you think are important?

I don't believe that citation is a reliable metric, since there are areas with more papers than others, so more quotes. Therefore, in my opinion should take into account a set of factors as impact...

04 May 2018 9,692 2 View

What would be the price ratio between materials for semiconductor manufacturing? SiC, GaN, GaAs, for exemple?

Hi, The semiconductor industry continues to accelerate the production of devices with new materials, such as SiC, GaN, GaAs, which have better characteristics than silicon. But what would be the...

03 April 2018 8,704 0 View

Did we come at a time when the improvement in computational hardware has evolved more than the software can keep up?

I realize that the evolution of the hardware in computers has not been evolving as in the past, I believe due to the limitations of the software. How can this be bypassed? What research highlights...

03 April 2018 9,200 0 View

How is the use of photovoltaic energy encouraged in your country?

How is the incentive for photovoltaic energy in your country? What are the results achieved? This is a discussion that can greatly help understand the growth of PV systems.

03 April 2018 2,496 1 View

What better way to prove learning?

This discussion aims to gather ways to prove success in the learning process, within a new moment of education with the advance of Industry 4.0.

03 April 2018 8,891 2 View

Could you recommend some articles on Urban Transportation System optimization and Innovation?

13 August 2024 2,595 3 View

Can you connect an HPLC to a Mass Spec only at a certain time point?

Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...

11 August 2024 8,141 3 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

How does grain and grain boundary affect the ceramic when studying its dielectric properties?

I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...

07 August 2024 5,177 3 View

How can major oxides determined by ICP-MS/ES be normalized to 100% volatile free? How does this connect with LOI?

I am analyzing cherts from different sources found within one specific geologic formation using ICP-MS/ES. My committee was asking this question about my analysis. I was not sure how to answer this

05 August 2024 7,902 3 View

Why is the molecule's orientation with an electric field affect polarizability?

Why is the molecule's orientation with an electric field affect polarizability? Electrons are diffuse enough to be independent with respect to orientation and effect of electric field on...

03 August 2024 7,843 1 View

How do environmental toxins interact with genetic predispositions to increase cancer risk?

I am currently researching the impact of environmental toxins on children's health and would greatly appreciate insights from experts in the field. If you are an expert or researcher working on...

02 August 2024 2,627 1 View

Conjugation of PEG-Amine to an Amino Acid Using EDC?

I am attempting to conjugate PEG to an amino acid at the C-terminus, for the purposes of producing nanoparticles. I have been told that PEG modified with amine groups can be used for this purpose,...

31 July 2024 2,033 1 View

A Question about Phd thesis?

Hello everyone What is your opinion about the introduction of an expert decision support system in which the rules are extracted from existing data without human intervention, instead of being...

31 July 2024 5,785 4 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View