How to homogenize the chitosan and EVA monomer?

i am have make thin films using chitosan and EVA , which is the good solvent to get the homogenize mixture

08 September 2018 7,759 0 View

Does someone have the room temperature curing monomer of acrylate polymer?

I am studying the UV curing and room temperature curing effect in acrylate polymer. but i do not have room temperature curing monomer or polymer, so i would like to know if someone here could...

06 July 2018 1,579 0 View

How to simulation of thin film nanocomposite by COMSOL for gas adsorption?

simulation of thin film

03 April 2017 3,597 1 View

What is the decomposition temperature of polyethylene glycol (PEG)

If i have melt with DMSO what is the decomposition temperature of polyethylene glycol (PEG) polymer

06 July 2016 6,725 3 View

Looking for Materials with high thermal expansion coefficient and high temperature resistance?

03 March 2021 8,272 1 View

What is your perception on using visual analysis or quantitative approaches to evaluate data from single-case research designs (n of 1 trials)?

Results of single-case research designs (i.e., n-of-1 trials) are often evaluated by visually inspecting the time-series graph and computing quantitative indices. A question our research team is...

03 March 2021 687 1 View

Why can't make aluminum nitride film successfully by use sputter?

We use reactive sputtering process to make aluminum nitride film, and want to make c-axis aluminum nitride film on a silicon substrate, but the crystal orientation cannot be seen with...

03 March 2021 7,975 3 View

Research on Supply Chain Management in Indian context?

Hi, I am planning to apply for the PhD degree in the Supply Chain Mgt. with specific area of "Cold Storage warehouses" during Pandemics and wars. Where lock downs and shut downs are frequent....

02 March 2021 285 2 View

How to address this issue in the analysis of Real-Time PCR results?

To dear Researchers, I was analyzing a series of concentration for estimation of Real-Time PCR efficiency. The concentration was 1:10. I used MS-excel to evaluate Slope. The result of slope was -8...

01 March 2021 8,683 4 View

How to check the uv-vis absorption of nanoparticle by surface plasmon resonance?

I try to check the uv-vis absorption of Indium nanoparticle. Now I am measuring in solution, can I measure it in the form of a film?

01 March 2021 930 3 View

1 nm thick MgO thin-film to be deposited on Si wafer using thermal evaporation. What will be the optimum deposition conditions?

Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.

28 February 2021 3,640 3 View

Why do the air flow results vary totally when adding scalar in CFD ?

Dear All, We are using Autodesk cfd to calculate the air flow in a single sided naturally ventilated room, where air flow depends only on buoyancy due to temperature difference between inside and...

25 February 2021 9,602 4 View

What is the suitable range of Sulfur content and Viscosity of Heavy fluid Oil that used in Kiln?

What is the disadvantages of high sulfur content to the ceramic burning process? and what is the effect of outranged viscosity?

24 February 2021 8,219 2 View

How to make a time series imputation benchmark ?

Hello ! In a work, I have to benchmark different algorithms to fill in missing values in time series. I insist on the fact that this is imputation and not forecasting. In my case, I have access...

24 February 2021 7,470 7 View