What is the technique, method, etc. I can use this to make a General Purpose Macro-Processor GPMP smarter?

Prof. Ayad Ghany Ismaeel @Prof_Ayad_Ismaeel

01 January 2015 1 9K Report

From the view of design, which smart technique, method, etc. can I use it for GPMP.

Thesis The Design of General Purpose Macro-Processor

Manish Tembhurkar

Hello Ayad,

Try using this tool

Gema (http://gema.sourceforge.net/new/index.shtml)

I hope this will help you out with the issue.

With Regards,

Manish

http://gema.sourceforge.net/new/index.shtml

Badges
Science topic

More Prof. Ayad Ghany Ismaeel's questions See All

Daily a Social Web grow in users & applications. Reach a proper community collaboration a Semantic Web technologies can avoided this challenge?

Asking about how the Semantic Web technologies can be avoided this challenge ( proper community collaboration in E-learning management systems)

02 March 2015 5,487 0 View

The effect of having big differences (mutations, delete, insert, etc) in gene's sequence caused diseases but have similar protein?

The classify and diagnosis of diseases.

31 December 2014 3,845 0 View

The therapy of mutations gene caused diseases done within laboratory Accompanied by multiple problems, how can avoide in effective cost?

08 September 2014 6,676 1 View

Could you recommend some articles on Urban Transportation System optimization and Innovation?

13 August 2024 2,595 3 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

A Question about Phd thesis?

Hello everyone What is your opinion about the introduction of an expert decision support system in which the rules are extracted from existing data without human intervention, instead of being...

31 July 2024 5,785 4 View

Difficulty with permittivitt and Magnetic Permeability Calculations?

Difficulty with permittivitt and Magnetic Permeability Calculations Hello everyone, I have all the parameters related to the calculations of the permittivitty and magnetic permeability...

30 July 2024 5,206 1 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

After a lot of feature engineering for CTR modeling, it feels like it's basically the end of iteration? I mean, it's not cost-effective to keep doing?

After a lot of feature engineering for click-through rate modeling, it feels like it's basically the end of iteration? I mean, it's not cost-effective to keep doing it?

29 July 2024 4,955 0 View

How to use Desmond in HPC ?

Our department has recently acquired an HPC (High-Performance Computing) system, and I'm thrilled to take my molecular dynamics calculations to the next level using Desmond. I used to run my...

28 July 2024 6,553 1 View

Ternary in Electrical Engineering?

Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...

28 July 2024 5,771 2 View

How to conduct a sensitivity power analysis for Kendall's Tau?

Is there a straightforward way to conduct a sensitivity power analysis for a Kendall's Tau correlation? I was considering using the sensitivity setting and "Correlation: point biserial model" test...

28 July 2024 6,133 8 View