What is the purpose of a resistor spark plug?

05 May 2017 1 8K Report

resistor spark plugs use a 5k ohm ceramic resistor in the spark plug.

The purpose of resistor spark plug to suppress ignition noise generated during sparking. NGK strongly recommends using resistor spark plugs in any vehicle that uses on-board computer systems to monitor or control engine performance

Badges
Science topic

More Noor Amalina Amran's questions See All

What is the sympton is caused as a result of brake disc run out?

brake disc run out means variation on disc thickness.from my some reading,its somethings about vibration must be consider.

03 April 2017 10,058 0 View

How does grain and grain boundary affect the ceramic when studying its dielectric properties?

I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...

07 August 2024 5,177 3 View

Does it exist some special technique for cutting ceramic membranes for Cross-sectional FESEM images?

Does it exist some special technique for cutting ceramic membranes for Cross-sectional FESEM or SEM images?

25 July 2024 5,482 2 View

How does the crystallite size and microstrain distribution influence the mechanical properties of a ceramics?

10 July 2024 3,444 4 View

Hey there, What is The best recommended solvent( safe for use) to dissolve or remove Z-90 Adhesive from ceramic surfaces ?

as of my knowledge z90 is acrylic based sealant adhesive.

09 July 2024 8,660 4 View

Is there a subtle distinction between the terms "substitution" and "doping"?

Dear Prof, is there a subtle distinction between the terms "substitution" and "doping" when referring to modifying ceramic dielectric materials for example Na0.5Bi0.5TiO3? Is there any difference...

08 July 2024 2,043 3 View

What does the area under the curve signify in dielectric loss tangent studies for solid polymer electrolyte ?

In solid ceramic electrolyte what is the Physical significant of area under the curve in dielectric loss tangent studies ??

23 June 2024 4,354 1 View

Typical Viscosity of Ceramic Paste for Direct Ink Writing (extrusion) process?

What is the typical viscosity range for ceramic pastes used for the Direct Ink Writing (extrusion) process? I have read several articles, and all give different figures; I saw somewhere else that...

29 April 2024 4,417 2 View

Why reduce the DC conductivity after the addition of ceramic (LLZO) in polymer salt complex ????

In our case ,addition of lower wt% (2to 10wt%)of ceramic in polymer salt complex ,The DC conductivity is reduce as compared to the polymer salt complex but if we are going to the higher loading of...

27 April 2024 6,708 2 View

The effect of mold, mandrel and matrix error in hydraulic press machine on lamination defect of oxide ceramics?

If we divide the factors causing lamination defects in zinc oxide ceramic parts into two categories of equipment and materials. How much is the share of each? Can the conditions of the mold,...

16 April 2024 1,926 0 View

What are the underlying mechanism responsible for aging-related degradation in ferroelectric properties of KNN ceramics and how can we prevent it?

Ferroelectric materials like potassium sodium niobate (KNN) exhibit remarkable properties such as spontaneous polarization, which makes them valuable for various technological applications...

09 April 2024 593 0 View