Before spraying a coating material onto the stainless steel surface, sandblasting is used to prepare its surface and causes dust all over a part. Currently, we use a high-pressure air to blow dirt from a part. However, a dirt is agitated and needed to be controlled. Thus, is there any practical and effective method to control dirt?
Alternatively, instead of using a high-pressure air is there any other effective and economical method to clean a part after sandblasting?
Please noted that the application is for factory use.
Vadim Verlotski
There is no realistic alternative method other than cleaning by means of compressed air. With good exhaust air is however no problem.
0 votes
0 thanks
- Badges
- Science topic
- Similar topics
- Engineering
- Materials Engineering
- Coating
Similar questions and discussions