What is the flow stress value for zinc -aluminum alloy?

More Mohammed A. Almusawi's questions See All

What is the flow stress value for "Za-27" ?

Hi there, I need the flow stress standard value for "Za-27"

31 December 2014 5,104 1 View

How much is the thermal conductivity of the high temperature grease lubricants ?

How much is the thermal conductivity of the high temperature grease lubricants Appearance Smooth blue buttery Visual Dropping Point ºC 360

31 December 2014 4,779 4 View

How much is the thermal conductivity of the standard blue color high temperature grease lubricants ?

Items Typical Properties Test MethodAppearance Smooth blue buttery VisualDropping Point ºC 360

31 December 2014 7,437 0 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

Is there anyone with experience in TEM analysis who can assist with a manuscript for an upcoming journal?

Hello dear colleagues, We have prepared a manuscript on NiTi-based alloys and are seeking a second opinion on our current TEM results. If you are a Ph.D. holder with experience in TEM and have...

07 August 2024 9,563 0 View

How select composition for ods-high entropy alloys?

31 July 2024 2,795 1 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

Ternary in Electrical Engineering?

Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...

28 July 2024 5,771 2 View

What topic or subject does Production Engineering need to address more?

Contemporary scores or innovations in scientific approaches. Hybrid methodologies, emerging themes and cross-cutting issues?

27 July 2024 648 3 View

I am trying to obtain microstructure for Mg-Zn-Sn alloy?

Any suggestions with respect to etchant composition and holding time?

27 July 2024 6,925 2 View

Will the catalytic effect of retained austenite happens in steels including RA?

The catalytic effect of retained austenite refers to the phenomenon wherein quenching steels with a small amount of retained austenite, when subjected to tempering at a specific temperature...

27 July 2024 8,508 0 View

Can a shoot-through event of a tri-state digital buffer cause momentary Hi-Z state?

// interested in the difference between floating events and short circuits.

22 July 2024 6,565 0 View

E. Garcia-Sanchez

Engmoh, I reccomend you take a look in www.matweb.com there is a database with a lot of materias and their properties at least mechanical. But for Recrystallization, the best way is searching in papers. Also for recrystallization the Humpreys (book) is an excellent reference.

Raheem Sadoon Jamel

if you do not find the answer from researching .you have to do experiment test by tensile test and take the log for stress and strain to determine n and k

flow stress=K strain ^n

best Regards