What is the difference between powder metallurgy and other manufacturing techniques?

11 November 2017 1 9K Report

what are the advantages of powder metallurgy techniques over other manufacturing techniques?

Article A deformation-processed Al-matrix/Ca-nanofilamentary composi...

Thesis Structure-property relationships in an Al matrix Ca nano lam...

high yield, for complex shape, dimensional accuracy, some MMC can only be produced by P/M, not by melting processing due to intermetallics formation etc

Badges
Science topic

Similar topics
Econ
Manufacturing

What is the production process of CaFe ferroalloys?

I looking for ferro calcium production process

03 March 2021 1,755 4 View

12% ledeburitic cold work tool steel, etched for revealing retained austenite, any help for clarifying?

Hello everyone. Given microstructure image belongs to a 12% ledeburitic cold work tool steel (annealed and tempered). The sample was etched with picral (100 mL ethanol and 4 g picric acid). I...

02 March 2021 4,119 3 View

Why Austenite grains in steel show much more twinning than ferrite grains?

It is oftentimes said to be a distinctive metallographic trait that differentiates a fully austenitic and a fully felly ferritic steel without etching that might distinguish between two. Why...

02 March 2021 728 2 View

Which is the most convenient manufacturing software for Additive Manufacturing?

Which tools can be used to generate machine codes for additive manufacturing?

02 March 2021 7,220 2 View

Can anyone share his experience regards Smoothing in origin?

I am working on TiO2 composite material and the results of XRD have a lot of small/junk peaks and while I apply a smooth filter in Origin then the other characteristics peaks disappear so anyone...

26 February 2021 8,183 3 View

What software programs can directly simulate Additive Manufacturing Directed Energy Deposition (DED)?

I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....

24 February 2021 4,428 3 View

How to differentiate the economic productivity in agriculture and in manufacturing sector?

Most of the references I found were on the economic productivity in agriculture but very limited application in manufacturing sector. I would appreciate if anyone could share the references on...

15 February 2021 8,342 7 View

XRPD Quantification - Building a calibration curve of drug excipient?

I am aiming to utilise XRPD to quantify a drug excipient within a drug product and have been having a little trouble building the calibration curve to allow for this quantification up until this...

10 February 2021 6,145 3 View

What could be the reason for XRD pattern starting from very high counts/intensity at 3 degree 2 theta?

I am working on XRD analysis of the clay minerals from the sea sediments. My XRD pattern shows very high counts at the start of the XRD pattern (3 degree 2 theta) which is very unusual. The counts...

31 January 2021 4,493 9 View

For Carbon-emission free steelmaking by electrolysis with nonoxidizable electrode in EAF, what would be electrode material?

While CCS can be employed along with a conventional Carbon-efficient EAF steelmaking process (especially from iron ore) or even Hydrogen or hydrocarbon can bee passed through central electrode,...

30 January 2021 3,378 1 View