Need some confirmation and any source PDF
Hello everyone, I am conducting cyclic voltammetry experiments on my polymeric composite system Polyimide/polysiloxane/graphene using a three electrode setup and 1M KOH electrolyte. I am obtaining...
26 September 2018 2,947 3 View
Initially we extracted with alcohol it is showing anti microbial activity but its not stable, hence we used buffer of pH 4, 7 and 9. Now the zone of inhibition is stable and for further...
12 December 2017 8,032 10 View
Hello I has to carry CFD analysis of slurry erosion.. how to insert sand particles in the fluid medium in ANSYS FLUENT
16 October 2016 2,649 2 View
I anwar by adsorption or reaction ..but it is either more method...
02 March 2021 4,811 2 View
I took measurements of different concentrations of 15 nm and 5 nm Au nano particle solutions. I'm trying to determine which concentration I measured gives the best reading overall. I also...
02 March 2021 7,626 1 View
Good day to all, I have no experience with light emitting diodes. I am building a glass mini flume to demonstrate the photo degradation of Methylene Blue in water running over self cleaning...
26 February 2021 4,026 5 View
In the formation of Zno nano particles process, after drying at 120 degree C, my zno nano particles are completely white but when i calcine it for 450 degree C it converts into grey colour. i...
26 February 2021 2,435 4 View
I want to remove PDMS oligomers from the surface of nanolayers. I have just read a very helpful paper about the compatibility of PDMS with different solvents( Solvent Compatibility of...
24 February 2021 7,845 5 View
We own a small cPCR thermal cycler from Roche, Lightcycler Nano, which is convenient for backup quick runs. Recently, Roche has discontinued the plastics for it and they offer no alternative from...
17 February 2021 8,694 5 View
I have chemically synthesized silver nanoparticle to combat microbes on wound site. I have used many methods of synthesis, but I found minimal field of silver NP product.I am getting whitish...
11 February 2021 4,964 13 View
Dear colleagues. How can we implement the kinetics of the polymerization of aromatic amines in easier and simpler ways? Are there simpler methods for Nano polymers (other than those obtained with...
09 February 2021 5,783 3 View
Hello everyone! Is a normal value 295.8 ug/ul for cDNA? If not what does it mean? Where is the mistake? The measurement was done with nano drop. Thank you!
09 February 2021 6,202 1 View
I am adding 0.1wt percent MWCNT to glass fiber epoxy composite and want to determine the volume fraction of the MWCNT from this composite but I don't know how to calculate it. can anyone help me...
09 February 2021 8,883 3 View