What is the best filter to use to collect diesel soot in order to analyse it by FTIR and TGA analysis?

More Nahil Serhan's questions See All

How to know total number of neighbor node of a given node in contiki?

I am using contiki 3.0 and I want to calculate rank of a RPL node based on total number of neighbor node that node have. But, I don't know from where I could get it. I have tried the...

28 May 2020 7,326 3 View

How can i produce NO2 from the urea?

Ammonia and oxygen can react together to produce nitrogen dioxide and water: 4NH3+7O2→ 4NO2+6H2O Any idea what is the catalyst needed to generate this reaction? or in case this conversion can...

28 January 2019 4,429 2 View

I am looking for a Golgi marker antibody (preferably TGN) which works for immunofluorescence in methanol-fixed mouse cells. Any suggestions?

thanks.

05 November 2014 3,940 1 View

Could you recommend some articles on Urban Transportation System optimization and Innovation?

13 August 2024 2,595 3 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

A Question about Phd thesis?

Hello everyone What is your opinion about the introduction of an expert decision support system in which the rules are extracted from existing data without human intervention, instead of being...

31 July 2024 5,785 4 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

After a lot of feature engineering for CTR modeling, it feels like it's basically the end of iteration? I mean, it's not cost-effective to keep doing?

After a lot of feature engineering for click-through rate modeling, it feels like it's basically the end of iteration? I mean, it's not cost-effective to keep doing it?

29 July 2024 4,955 0 View

How to use Desmond in HPC ?

Our department has recently acquired an HPC (High-Performance Computing) system, and I'm thrilled to take my molecular dynamics calculations to the next level using Desmond. I used to run my...

28 July 2024 6,553 1 View

Ternary in Electrical Engineering?

Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...

28 July 2024 5,771 2 View

What topic or subject does Production Engineering need to address more?

Contemporary scores or innovations in scientific approaches. Hybrid methodologies, emerging themes and cross-cutting issues?

27 July 2024 648 3 View

Can a shoot-through event of a tri-state digital buffer cause momentary Hi-Z state?

// interested in the difference between floating events and short circuits.

22 July 2024 6,565 0 View

Paul Gateau

I suppose FTIR is for analysis of organic compounds in soot. So you have to extract those compounds with a solvent. The problem is temperature of the filter and the size or pores and the size of soot particulates.

Fadzli Ibrahim

May I know where did this filter applied? Is it at exhaust manifold? Because I'm working to collect soot as well for my study...