What happens when LED display is exposed to sunlight for longer durations?

Prasanth Chilakamarri @Prasanth_Chilakamarri

02 February 2018 0 8K Report

Damage to coatings, plastics, inks, LCD, contrast degradation, color degradation, brightness, yellowing, cracking, peeling, brittleness, loss of tensile strength, delamination etc.

what kind of failure can happen and explain the mode of failure.

Badges
Science topic

Similar topics
Optics
Color

More Prasanth Chilakamarri's questions See All

How to investigate the quality of adhesive used in optical bonding of touchscreen to display in a LED display?

When LED display is exposed to UV radiation for longer time how it will effect its performance?

01 February 2018 3,082 0 View

Is modulus of rigidity which is also refered to as shear modulus G different in different directions?

Gxy, Gyz, Gzx are different or they are all the same and my notation makes no sense for a given material.

31 December 2017 1,242 8 View

Is skin yellowness an numerical or ordinal variable?

I have a response variable called skin yellowness, which I will measure via a scored color chart, whereby 1 is pale yellow and 15 is orange. I'm not sure if this counts as an ordinal variable,...

11 August 2024 4,793 1 View

Which type of compound does lamda max of 218 indicate in a uv-vis spectrum of a partially purified compound through column and TLC?

A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...

11 August 2024 9,801 2 View

Baseline drift in HPLC? What causes this?

Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!

11 August 2024 3,770 4 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

What may be the reasons for failures of Tube toi Tube Sheet Joints in Boiler Drum ?

We have observed that tube to tube sheet joint leaked in our boiler and needs to overcome same by knowing the root cause.

08 August 2024 3,161 0 View

U you think We need a website software of Blackbody radiation law expert software?

A website software of Blackbody radiation law expert software can used through the following web site. http://39.105.188.151:3000/index

07 August 2024 1,706 0 View

Please explain how the plastic input value should be considered from the true stress-strain curve for the bilinear elastoplastic material model ?

I am working on Abaqus/Explicit(Quasistatic ) for the deformation of the auxetic structure model. Please explain how the plastic input value should be considered from the true stress-strain curve...

05 August 2024 454 3 View

Could dyes amplify the spectrum of light to a specific wavelength?

I am interested to know the behavior of dyes toward light. Specifically, Blue dyes re-emit the spectrum, especially from the green zone (known as principal in LED lamps, and blue dyes are known...

05 August 2024 3,290 1 View

Can anyone explain why there is not any color bands in the middle portion of the tensile coupon?

Details of the Analysis. Static Analysis Composite Layup Continuum Shell Elements FRP Material (Elastic and Hashin Damage)

03 August 2024 8,538 4 View

I need the datasets of Microgrid for system identification?

Hi I am working on data driven model of the microgrid, for that, i need the reliable datasets for the identification of MG data driven Model. Thanks

02 August 2024 5,748 4 View